Auto Parts Search
2009 Toyota Tacoma CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Toyota REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Toyota Tacoma AUTOMOBILES
DRIVESHAFT U-JOINT, Replace -> Assembly -> Disassemble
Vehicle: 2009 Toyota Tacoma X-RUNNER 4.0 V6 GAS
Disassemble
This procedure describes a driveline equipped with cardan joint in tube yoke. Driveline equipped with companion/slip yoke repeat steps to remove remaining cardan joint.
- Place driveshaft on suitable workbench. Do not damage driveshaft when servicing on workbench. Ensure driveline and components are reference marked to prevent driveline imbalance.
- Tap outside of bearing cap with a drift to loosen snap ring.
- Remove snap rings from both sides of yoke using suitable tool.
- Position yoke with grease fitting pointing up, if equipped.
- Position socket with an inside diam...
CLICK HERE TO GET FULL ACCESS TO 2009 Toyota Tacoma DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2009 Toyota Tacoma AUTOMOBILES
Wiring Diagrams -> Wire Color Code Identification
Vehicle: 2009 Toyota Tacoma 4.0 V6 GAS
Refer to Fig. for wiring...
[[table data]]CLICK HERE TO GET FULL ACCESS TO 2009 Toyota Tacoma TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2009 Toyota Tacoma AUTOMOBILES
Starter, Replace -> 2WD and Pre-Runner -> 4WD
Vehicle: 2009 Toyota Tacoma PRE Runner 4.0 V6 GAS
2WD and Pre-Runner
- Disconnect cable from battery ground terminal.
- Remove four bolts, then remove engine under cover.
- Remove three bolts, then remove manifold stay.
- Remove bolt, then separate earth wire harness from cylinder block.
- Disconnect terminal 50 connector from starter assembly.
- Remove nut, then disconnect wire harness from terminal 30.
- Remove two bolts, then remove starter assembly.
- Remove starter from vehicle.
- Reverse procedure to install, noting the following:
- Torque starter assembly with two bolts to 27 ft. lbs.
- Torque wire harness to terminal 30 nut to 84 in. lbs.
- Torque ground...
CLICK HERE TO GET FULL ACCESS TO 2009 Toyota Tacoma STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2009 Toyota Tacoma AUTOMOBILES
Cabin Air Filter Service -> Toyota -> 2006-09 Tacoma
Vehicle: 2009 Toyota Tacoma PRE Runner 4.0 V6 GAS
On 2006 models, the cabin air filter should be replaced every 36 months or 30,000 miles. The filter should be replaced more often if air flow is less than normal.
On 2007-09 models, the cabin air filter should be replaced every 24 months or 20,000 miles. The filter should be replaced more often if air flow is less than normal.
- Open the glove compartment door.
- Slide off damper rod from glove compartment door, Fig. .
- Push inward at each side of the glove compartment door to disengage the retainers, then lower...
CLICK HERE TO GET FULL ACCESS TO 2009 Toyota Tacoma CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2009 Toyota Tacoma AUTOMOBILES
Toyota -> Low Coolant Lamp ->
Vehicle: 2009 Toyota Tacoma PRE Runner 4.0 V6 GAS
This lamp will be illuminated when the coolant level in the radiator drops below a pre-determined point. To reset the lamp, bring the c...
CLICK HERE TO GET FULL ACCESS TO 2009 Toyota Tacoma MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2009 Toyota Tacoma AUTOMOBILES
Heater Hose, Replace -> Bypass -> Inlet -> Outlet
Vehicle: 2009 Toyota Tacoma 4.0 V6 GAS
Inlet
- Disconnect battery ground cable.
- Drain cooling system into a suitable container by loosening drain plug of radiator.
- Reposition hose clamp at heater core.
- Remove hose from heater core.
- Reposition hose clamp at water outlet.
- Remove hose from water outlet.
- Remove hose from vehicle.
- Reverse procedure to install.
Outlet
- Disconnect battery ground cable.
- Drain cooling system into a suitable container by loosening drain plug of radiator.
- Reposition hose clamp at ...
CLICK HERE TO GET FULL ACCESS TO 2009 Toyota Tacoma RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2009 Toyota Tacoma AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2009 Toyota Tacoma PRE Runner 4.0 V6 GAS
- Rotate or lift the belt tensioner arm, using a suitable tool to relieve tension from dr...
CLICK HERE TO GET FULL ACCESS TO 2009 Toyota Tacoma SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 2009 Toyota Tacoma AUTOMOBILES
OEM TSB listings for most 2009 Toyota Tacoma cars and light trucks sold in the U.S. from 1985+.
Document: MIL ON DTC P011B with Block Heater Installed on 2TR-FE Engine Vehicle: 2009 Toyota Tacoma 2.7 L4 GAS Auto Systems: |
Document: MIL ON DTC P0705 Vehicle: 2009 Toyota Tacoma 2.7 L4 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2009 Toyota Tacoma TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2009 Toyota Tacoma AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2009 Toyota Tacoma cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2009 Toyota Tacoma cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2009 Toyota Tacoma cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2009 Toyota Tacoma cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2009 Toyota Tacoma SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2009 Toyota Tacoma vehicle. |
Access the Complete guide! |