Auto Parts Search
We have info for following modifications of 2010 Jeep Patriot
- 2010 Jeep Patriot Limited 2.4 L4 GAS, CC:2360, CID:144, Fuel Injection, Aspiration:144, Engine VIN:, Desg:B
- 2010 Jeep Patriot Limited 2.4 L4 GAS, CC:2360, CID:144, Fuel Injection, Aspiration:144, Engine VIN:, Desg:B
- 2010 Jeep Patriot Sport 2.0 L4 GAS, CC:1998, CID:122, Fuel Injection, Aspiration:122, Engine VIN:, Desg:A
- 2010 Jeep Patriot Sport 2.4 L4 GAS, CC:2360, CID:144, Fuel Injection, Aspiration:144, Engine VIN:, Desg:B
- 2010 Jeep Patriot Sport 2.4 L4 GAS, CC:2360, CID:144, Fuel Injection, Aspiration:144, Engine VIN:, Desg:B
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Jeep Patriot AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Jeep Patriot cars and light trucks from 1990+.
DRIVESHAFT, Replace
Vehicle: 2010 Jeep Patriot Limited 2.4 L4 GAS
Never allow propeller shaft to hang while connected to Power Transfer Unit (PTU), rear driveline module flanges or center bearings. If propeller shaft section is hung unsupported, damage may occur to joint, boot and/or center bearing from over-angulation. This may result in vibration/balance issues. A helper may be needed.
- Raise vehicle on hoist.
- Mark propeller shaft and...
CLICK HERE TO GET FULL ACCESS TO 2010 Jeep Patriot DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Jeep Patriot AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Jeep Patriot cars and light trucks from 1990+.
DRIVESHAFT U-JOINT, Replace
Vehicle: 2010 Jeep Patriot Limited 2.4 L4 GAS
Clamp only the narrow forged portion of the yoke in the vise. Failure to heed caution may result in damage.
- Remove axle shaft.
- Remove bearing cap retaining snap rings. Saturate the bearing caps with penetrating oil prior to removal.
- Place socket (receiver) with inside diameter larger than bearing cap against yoke and perimeter of bearing cap to be removed.
- Pla...
CLICK HERE TO GET FULL ACCESS TO 2010 Jeep Patriot DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Jeep Patriot AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Jeep Patriot cars and light trucks from 1990+.
DRIVESHAFT, Replace
Vehicle: 2010 Jeep Patriot Sport 2.4 L4 GAS
Never allow propeller shaft to hang while connected to Power Transfer Unit (PTU), rear driveline module flanges or center bearings. If propeller shaft section is hung unsupported, damage may occur to joint, boot and/or center bearing from over-angulation. This may result in vibration/balance issues. A helper may be needed.
- Raise vehicle on hoist.
- Mark propeller shaft and...
CLICK HERE TO GET FULL ACCESS TO 2010 Jeep Patriot DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Jeep Patriot AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Jeep Patriot cars and light trucks from 1990+.
DRIVESHAFT U-JOINT, Replace
Vehicle: 2010 Jeep Patriot Limited 2.4 L4 GAS
Clamp only the narrow forged portion of the yoke in the vise. Failure to heed caution may result in damage.
- Remove axle shaft.
- Remove bearing cap retaining snap rings. Saturate the bearing caps with penetrating oil prior to removal.
- Place socket (receiver) with inside diameter larger than bearing cap against yoke and perimeter of bearing cap to be removed.
- Pla...
CLICK HERE TO GET FULL ACCESS TO 2010 Jeep Patriot DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Jeep Patriot AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Jeep Patriot cars and light trucks from 1990+.
CV AXLE SHAFT, Replace -> Front -> Install -> Rear -> Remove
Vehicle: 2010 Jeep Patriot Sport 2.4 L4 GAS
Front
Remove
Boot sealing is vital to retain special lubricants and to prevent foreign contaminants from entering CV joint. Mishandling, such as allowing assemblies to dangle unsupported, or pulling or pushing ends can cut boots or damage CV joints. During removal and installation procedures, always support both ends of halfshaft to prevent damage.
The halfshaft, when installed, acts as a bolt and secures the front hub/bearing assembly. If vehicle is to be supported or moved on its wheels with a halfshaft removed, install a PROPER-SIZED BOLT AND NUT through front hub. Torque...
CLICK HERE TO GET FULL ACCESS TO 2010 Jeep Patriot DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Jeep Patriot AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Jeep Patriot cars and light trucks from 1990+.
DRIVESHAFT U-JOINT, Replace
Vehicle: 2010 Jeep Patriot Sport 2.0 L4 GAS
Clamp only the narrow forged portion of the yoke in the vise. Failure to heed caution may result in damage.
- Remove axle shaft.
- Remove bearing cap retaining snap rings. Saturate the bearing caps with penetrating oil prior to removal.
- Place socket (receiver) with inside diameter larger than bearing cap against yoke and perimeter of bearing cap to be removed.
- Pla...
CLICK HERE TO GET FULL ACCESS TO 2010 Jeep Patriot DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2010 Jeep Patriot vehicle. |
Access the Complete guide! |