Auto Parts Search
BRAKE SERVICE PROCEDURES FOR 2000 Audi TT AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Audi TT cars and light trucks from 1990+.
Anti-lock Brakes -> Diagnosis & Testing -> A4, A6, A8, S4 & S6 -> ABS Return Pump Does Not Run, Relay Good, Tester In Position 3 -> ABS Return Pump Does Not Run, Tester In Position 3 -> Accessing Diagnostic Trouble Codes (DTC) -> Clearing Diagnostic Trouble Codes -> Diagnostic Tests -> Diagnostic Trouble Code Interpretation -> Electrical Testing -> Hydraulic Modulator High & Low Pressure Testing -> LED 1 & 3 Do Not Light, Tester In Position 1 -> LED 18 Does Not Light -> LED 19 Does Not Light -> LED 35 Does Not Light -> LED 4 Does Not Light, Tester In Position 1 -> LED 4, 2, 35, 18 & 19 Do Not Light, Tester In Position 1 -> LED For Alternator Does Not Go Out When Engine Starts -> LED For Alternator Does Not Light, Tester In Position 2 -> LED For Brakes Does Not Go Out When Brake Pedal Is Depressed -> LED For Brakes Does Not Light -> No Response From Selected Sensor, Tester In Position 6 -> Read Measuring Value Block -> S6 -> Sensor Signal On Meter Below Minimum Value -> TT -> With LED Type Tester -> With Scan Tool -> Wrong Solenoid Valve Operates, Tester In Position 5
Vehicle: 2000 Audi TT 1.8 L4 GAS
With LED Type Tester
LED 1 & 3 Do Not Light, Tester In Position 1
Refer to Fig. ,for LED identification numbers. Weaker illumination of an LED indicates a contact resistance in respective circuit.
- Inspect for continuity between ABS control unit connector terminal 34 and ground at battery ground cable (LED 1), Fig. .
- Inspect for continuity between ABS control unit connector terminal 10 and ground at battery ground cable (LED 3).
- If continuity does not exist, repair shorted or open circuit.
LED 4 Does Not Light, Tester In Position 1
Refer to Fig. ,for LED identification. Weaker illum...
[[table data]] [[table data]] [[table data]]CLICK HERE TO GET FULL ACCESS TO 2000 Audi TT BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Audi TT AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Audi TT cars and light trucks from 1990+.
Anti-lock Brakes -> System Coding -> TT
Vehicle: 2000 Audi TT 1.8 L4 GAS
TT
Refer to Fig. fo...
CLICK HERE TO GET FULL ACCESS TO 2000 Audi TT BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Audi TT AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Audi TT cars and light trucks from 1990+.
Power Brake Units -> Power Brake Unit Service -> A4 & S4 -> A6, Cabriolet & S6 -> A8 -> Hydraulic Booster/Servo -> Vacuum Booster
Vehicle: 2000 Audi TT 1.8 L4 GAS
Hydraulic Booster/Servo
- Remove master cylinder as outlined under "Hydraulic Brake System."
- Disconnect hydraulic lines from booster/servo.
- Remove brake booster/servo attaching bolts.
- Disconnect booster pushrod from brake pedal.
- Reverse procedure to install, noting the following:
- Adjust pushrod length to 9.04-9.08 inches from face of booster/servo unit to center of clevis hole.
- Torque booster mounting bolts to 18 ft. lbs.
Vacuum Booster
A4 & S4
- Remove master cylinder as outlined under "Hydraulic Brake System" section.
- Disconnect hydraulic lines from brake servo unit.
- Remove stowage area ...
CLICK HERE TO GET FULL ACCESS TO 2000 Audi TT BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Audi TT AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Audi TT cars and light trucks from 1990+.
Anti-lock Brakes -> Troubleshooting
Vehicle: 2000 Audi TT 1.8 L4 GAS
Refer to "Diagnosis ... "
CLICK HERE TO GET FULL ACCESS TO 2000 Audi TT BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Audi TT AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Audi TT cars and light trucks from 1990+.
Disc Brakes -> Single Piston Rear Disc Brakes -> Tightening Specifications
Vehicle: 2000 Audi TT 1.8 L4 GAS
CLICK HERE TO GET FULL ACCESS TO 2000 Audi TT BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Audi TT AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Audi TT cars and light trucks from 1990+.
Disc Brakes -> ITT FN 3 Single Piston Front Brakes -> Brake Pad Service
Vehicle: 2000 Audi TT 1.8 L4 GAS
- Raise and support vehicle, then remove front tires.
- If brake pads are to be used again, mark installed positions for installation reference.
- Remove caliper guide pin caps.
- Pry brake pad retaining spring out from brake caliper housing using a suitable screwdriver.
- Remove caliper guide pins.
- Remove caliper housing, then position aside using suitable wire or rope.
- Remove brake pads.
- Clean brake caliper housing using a suitable methylated spirit. Pay close attention to pad bonding surfaces. They must be free of all grease and adhesive residues.
- Siphon off a small amount of brake fluid fro...
CLICK HERE TO GET FULL ACCESS TO 2000 Audi TT BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2000 Audi TT vehicle. |
Access the Complete guide! |