Auto Parts Search
We have info for following modifications of 2008 Audi A3
- 2008 Audi A3 2.0 L4 GAS, CC:1984, CID:121, Fuel Injection, Aspiration:121, Engine VIN:, Desg:F
- 2008 Audi A3 Quattro 3.2 V6 GAS, CC:3189, CID:195, Fuel Injection, Aspiration:195
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2008 Audi A3 AUTOMOBILES
Includes starter and alternator replacement procedures for domestic and imported 2008 Audi A3 cars and light trucks from 1990+.
Alternator, Replace
Vehicle: 2008 Audi A3 Quattro 3.2 V6 GAS
- Disconnect battery ground cable at battery.
- Disconnect mass air flow (MAF) sensor.
- Remove engine cover.
- Remove EVAP canister and move to side with lines connected.
- Rotate tensioner for ribbed belt toward right using a box wrench until both holes are in alignment and lock with a dowel, drill bit or allen wrench.
- Remove ribbed belt from alternator pulley.
- Remove tensioner.
- Remov...
CLICK HERE TO GET FULL ACCESS TO 2008 Audi A3 STARTER & ALTERNATOR REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2008 Audi A3 AUTOMOBILES
Includes starter and alternator replacement procedures for domestic and imported 2008 Audi A3 cars and light trucks from 1990+.
Starter, Replace
Vehicle: 2008 Audi A3 Quattro 3.2 V6 GAS
- Disconnect battery ground cable at battery.
- Remove air guide by releasing side retainers.
- Unclip lower air guide by releasing left and right retainers.
- Disengage lower air guide at mounts by moving lower air guide slightly to rear.
- Disconnect air guide pipe from lower air guide.
- Disconnect mass air flow (MAF) sensor.
- Remove air guide hose.
- Remove bolt and air filter housing.
- Remove cable tie for protective boot.
- Disconnect electrical c...
CLICK HERE TO GET FULL ACCESS TO 2008 Audi A3 STARTER & ALTERNATOR REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2008 Audi A3 AUTOMOBILES
Includes starter and alternator replacement procedures for domestic and imported 2008 Audi A3 cars and light trucks from 1990+.
Starter, Replace
Vehicle: 2008 Audi A3 2.0 L4 GAS
- Disconnect battery ground cable.
- Disconnect electrical connector at Mass Air Flow (MAF) Sensor.
- Remove engine cover.
- Remove and discard cable tie over protective sleeve.
- Disconnect electrical connector at starter.
- Fold back protective sleeve, remove nut at starter solenoid B+ terminal, and remove connector terminal.
- Remove ground cable from starter.
- Remove upper starter bolt.
- Raise and support vehicle.
- Release fasteners and remove center noise insulation.
- Disconnect electrical connector...
CLICK HERE TO GET FULL ACCESS TO 2008 Audi A3 STARTER & ALTERNATOR REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2008 Audi A3 AUTOMOBILES
Includes starter and alternator replacement procedures for domestic and imported 2008 Audi A3 cars and light trucks from 1990+.
Alternator, Replace
Vehicle: 2008 Audi A3 2.0 L4 GAS
- Disconnect battery ground cable.
- Disconnect electrical connector at Mass Air Flow (MAF) Sensor.
- Remove engine cover.
- Lift activated charcoal filter (with hoses still connected) out of bracket and set aside.
- If belt is to be reused mark direction of rotation, before removing drive belt. Belt damage will result if not reinstalled in proper direction.
- Relieve drive belt tension by turning tensioner clockwise, using a suitable tool.
- Lock tensioner in place, using a suitable tool.
- Re...
CLICK HERE TO GET FULL ACCESS TO 2008 Audi A3 STARTER & ALTERNATOR REPLACEMENT PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2008 Audi A3 vehicle. |
Access the Complete guide! |