Auto Parts Search
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Mitsubishi Endeavor AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Mitsubishi Endeavor cars and light trucks sold in the U.S. from 1990+.
Mitsubishi -> Air Bag Warning Lamp -> Except 2006-09 Raider
Vehicle: 2004 Mitsubishi Endeavor 3.8 V6 GAS
The diagnosis unit monitors the Supplemental Restraint System (SRS) and stores data concerning any faults detected in the system. When the ignition key is in the On or Start positions, the lamp should illuminate for approximately 7 seconds, then turn off. This indicates the system is operating proper...
CLICK HERE TO GET FULL ACCESS TO 2004 Mitsubishi Endeavor MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Mitsubishi Endeavor AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Mitsubishi Endeavor cars and light trucks sold in the U.S. from 1990+.
Mitsubishi -> Traction Control System (TCS) Warning Lamp -> Except 2006-09 Raider
Vehicle: 2004 Mitsubishi Endeavor 3.8 V6 GAS
The TCS warning lamp is used to warn of a system fault. It will be lit during engine start-up, but should go out when the self-diagnostic system determines that the system is functioning properly. The lamp will flash when the TSC is activated...
CLICK HERE TO GET FULL ACCESS TO 2004 Mitsubishi Endeavor MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Mitsubishi Endeavor AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Mitsubishi Endeavor cars and light trucks sold in the U.S. from 1990+.
Mitsubishi -> Tire Pressure Monitoring System (TPMS) Warning Indicator -> 2004-06 Endeavor -> Relearn -> Reset -> Tire Pressure Sensor ID Registration -> Warning Lamp
Vehicle: 2004 Mitsubishi Endeavor 3.8 V6 GAS
Reset
Tire Pressure Sensor ID Registration
- Connect a suitable scan tool to vehicle data link connector, Fig. .
- Follow scan tool instructions to enter "Tire Pressure Sensor ID Registration" mode.
- Select the number of tires that you want to register.
- Starting at any TPMS transmitter, emit a signal from the transmitter as follows:
- Ensure that TPMS transmitter location on wheel rim is clean.
- Position magnet tool No. MIT46716 or equivalent as shown in Fig. for at least 5 seconds.
- By holding the magnet as shown, a reed switch located inside the TPMS transm...
CLICK HERE TO GET FULL ACCESS TO 2004 Mitsubishi Endeavor MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Mitsubishi Endeavor AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Mitsubishi Endeavor cars and light trucks sold in the U.S. from 1990+.
Mitsubishi -> Malfunction Indicator Lamp (MIL) ->
Vehicle: 2004 Mitsubishi Endeavor 3.8 V6 GAS
Immediately after the ignition switch is placed in the On position, the MIL will light for 5 seconds to indicate proper operation. The MIL will illuminate to indicate an emission control item fault. After diagnosis and repair are complete, place the ignition switch in the Off position, then clear st...
CLICK HERE TO GET FULL ACCESS TO 2004 Mitsubishi Endeavor MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Mitsubishi Endeavor AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Mitsubishi Endeavor cars and light trucks sold in the U.S. from 1990+.
Mitsubishi -> Active Skid Control System (ACS) Warning Lamp ->
Vehicle: 2004 Mitsubishi Endeavor 3.8 V6 GAS
The ACS warning lamp is used to warn of a system fault. It will be lit during engine start-up, but should go out when the self-diagnostic system determines that the system is functioning properly. The lamp will flash when the ASC is activated. If the...
CLICK HERE TO GET FULL ACCESS TO 2004 Mitsubishi Endeavor MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Mitsubishi Endeavor AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Mitsubishi Endeavor cars and light trucks sold in the U.S. from 1990+.
Mitsubishi -> Automatic Transmission Oil Temperature Warning Lamp ->
Vehicle: 2004 Mitsubishi Endeavor 3.8 V6 GAS
This lamp will be illuminated when the automatic transmission fluid temperature is excessive. When...
CLICK HERE TO GET FULL ACCESS TO 2004 Mitsubishi Endeavor MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2004 Mitsubishi Endeavor vehicle. |
Access the Complete guide! |