1997 Chevrolet K1500 Suburban Brake Service (ONLINE REPAIR MANUALS)

C & K Series

Duo-Servo

Removal

• Raise and support vehicle.
• Mark relationship of wheel to hub, then remove tire and wheel assembly.
• On models equipped with full-floating axles, remove hub and drum assembly as described in "Drive Axles."
• On models equipped with semi-floating axles, proceed as follows:
• Install pin into park brake lever.
• Mark relationship of drum to axle.
• Remove rear brake drum retainers, as required.
• Remove rear brake drum.
• On all models, remove return springs and shoe guide, Fig. .
• Remove brake hold down springs and pins.
• Disconnect actuator lever and pivot.
• Remove lever return spri...

Disassemble

• Place accumulator compressor tool No. J-26889, or equivalent, around end of accumulator.
• Install nut onto stud as shown in Fig. , then depress the accumulator with a C-clamp.
• Remove retainer by using a punch.
• Release C-clamp and remove accumulator compressor tool.
• Remove accumulator, O-ring, retainer, plug and spring, Fig. .
• Remove retainer, output pushrod, baffle, piston return spring and retainer.
• Using a suitable saw, cut off eyelet of pedal rod, then remove the boot.
• Remove nut, bracket and bolts, then separate cover from housing.
• Remove piston assembly and seal...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, on models with hydraulic assist brakes, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brak...

Manual Bleed

• If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
• Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
• If master cylinder is suspected to have air in the bore, it must be bled first. To bleed master cylinder, proceed as follows:
• Disconnect forward brake pipe connection at master cylinder.
• Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
• Connect ...

The caliper assembly slides on its mounting surfaces, Fig. . Upon brake application, hydraulic pressure against the piston forces the inboard pad against the inboar...