Auto Parts Search

We have info for following modifications of 2001 Audi TT Quattro
- 2001 Audi TT Quattro 1.8 L4 GAS, CC:1781, Fuel Injection, Engine VIN:, Desg:C
- 2001 Audi TT Quattro 1.8 L4 GAS, CC:1781, Fuel Injection, Engine VIN:, Desg:T
- 2001 Audi TT Quattro 1.8 L4 GAS, CC:1781, Fuel Injection, Engine VIN:, Desg:X
BRAKE SERVICE PROCEDURES FOR 2001 Audi TT Quattro AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Audi TT Quattro cars and light trucks from 1990+.
Disc Brakes -> Lucas Rear Disc Brakes -> Tightening Specifications
Vehicle: 2001 Audi TT Quattro 1.8 L4 GAS
CLICK HERE TO GET FULL ACCESS TO 2001 Audi TT Quattro BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Audi TT Quattro AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Audi TT Quattro cars and light trucks from 1990+.
Power Brake Units -> Diagnosis & Testing -> Hydraulic Booster/Servo -> Pressure Accumulator Check Valve -> Pressure Accumulator Pressure Relief Valve -> Pressure Accumulator-Gas Pressure -> Vacuum Booster
Vehicle: 2001 Audi TT Quattro 1.8 L4 GAS
Hydraulic Booster/Servo
- With ignition Off, depress brake pedal approximately 20 times to reduce system pressure.
- Disconnect warning lamp switch electrical connector, then remove switch.
- Attach pressure gauge with hollow bolt and copper washers to brake servo unit. Attach thick copper washer between brake servo unit and banjo fitting and thin copper washer between hollow bolt and banjo fitting.
- Start engine and let idle until pressure gauge reading exceeds 2030 psi.
- If specified pressure is not reached, measure delivery rate of central hydraulic pump as follows:
- Turn ignition Off, ...
CLICK HERE TO GET FULL ACCESS TO 2001 Audi TT Quattro BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Audi TT Quattro AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Audi TT Quattro cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> A4 & S4 -> A6 & S6 -> A8 & S8 -> Brake Pressure Regulator -> Master Cylinder -> TT
Vehicle: 2001 Audi TT Quattro 1.8 L4 GAS
Master Cylinder
A4 & S4
- Remove driver's side storage compartment.
- Separate brake pedal from master cylinder pushrod as follows:
- Remove stop lamp switch.
- Insert brake pedal release tool No. T10006, or equivalent, from below, Fig. .
- Hold brake pedal tightly.
- Lift catch off push rod using a slight pull on release tool " A."
- Keep tension on tool to prevent pushrod from engaging catches.
- Separate brake pedal from master cylinder pushrod " B."
- Connect bleeder hose and bleeder bottle to lefthand front brake caliper bleeder valve, then open bleeder valve.
- Operate brake pedal to pump out as much ...
CLICK HERE TO GET FULL ACCESS TO 2001 Audi TT Quattro BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Audi TT Quattro AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Audi TT Quattro cars and light trucks from 1990+.
Disc Brakes -> ITT FN 3 Single Piston Front Brakes -> Brake Rotor, Replace
Vehicle: 2001 Audi TT Quattro 1.8 L4 GAS
Refer to "Strut, Replace" procedure in the "F... "
CLICK HERE TO GET FULL ACCESS TO 2001 Audi TT Quattro BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Audi TT Quattro AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Audi TT Quattro cars and light trucks from 1990+.
Disc Brakes -> ITT FN 3 Single Piston Front Brakes -> Brake Pad Service
Vehicle: 2001 Audi TT Quattro 1.8 L4 GAS
- Raise and support vehicle, then remove front tires.
- If brake pads are to be used again, mark installed positions for installation reference.
- Remove caliper guide pin caps.
- Pry brake pad retaining spring out from brake caliper housing using a suitable screwdriver.
- Remove caliper guide pins.
- Remove caliper housing, then position aside using suitable wire or rope.
- Remove brake pads.
- Clean brake caliper housing using a suitable methylated spirit. Pay close attention to pad bonding surfaces. They must be free of all grease and adhesive residues.
- Siphon off a small amount of brake fluid fro...
CLICK HERE TO GET FULL ACCESS TO 2001 Audi TT Quattro BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Audi TT Quattro AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Audi TT Quattro cars and light trucks from 1990+.
Anti-lock Brakes -> System Service -> Brake System Bleed
Vehicle: 2001 Audi TT Quattro 1.8 L4 GAS
Brake System Bleed
Refer t...
CLICK HERE TO GET FULL ACCESS TO 2001 Audi TT Quattro BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |