2003 Oldsmobile Bravada Brake Service (ONLINE REPAIR MANUALS)

Master Cylinder

• On models equipped with manual brake system, disconnect master cylinder pushrod from brake pedal.
• On all models, disconnect all wire conne...

General System

• Inspect components for damage or unusual wear. Replace as required.
• Inspect backing plate mounting bolts and ensure they are tight.
• Inspect wheel cylinders. Excessive fluid indicates cup leakage and need for wheel cylinder replacement. Slight amount of fluid is always present and is considered normal, acting as lubricant for cylinder pistons.
• Inspect adjuster screw operation. If satisfactory, lightly lubricate adjusting screw and washer with suitable brake lube. If operation is unsatisfactory, replace.
• Clean rust and dirt from shoe contact surfaces on backing plate using fi...

Manual Bleed

• If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
• Fill master cylinder reservoirs with suitable brake fluid.. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
• If master cylinder is suspected to have air in the bore, it must be bled first. To bleed master cylinder, proceed as follows:
• Disconnect forward brake pipe connection at master cylinder.
• Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
• Connect...

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level because of a chemical breakdown during use and a few precautions will minimize exposure.. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent excessiv...

Astro & Safari

• Apply parking brake.
• Disconnect reservoir and power steering hoses from booster.
• Remove master cylinder to brake booster retaining nuts.
• Position and support master cylinder away from booster.. Do not remove hydraulic lines from master cylinder.
• Remove booster rod from top of brake pedal.
• Remove booster mounting nuts from inside of vehicle.
• Remove booster assembly and gasket.
• Reverse procedure to install, noting the following:
• Torque booster mounting nuts to 27 ft. lbs.
• Torque master cylinder retaining nuts to 27 ft. lbs.
• Torque power steering hoses to booster n...

Disassemble

• Place accumulator compressor tool No. J-26889, or equivalent, around end of accumulator.
• Install nut onto stud as in. Fig. , then depress accumulator with a C-clamp.
• Remove retainer by using a punch.
• Release C-clamp and remove accumulator compressor tool.
• Remove accumulator, O-ring, retainer, plug and spring,. Fig. .
• Remove retainer, output pushrod, baffle, piston return spring and retainer.
• Cut off eyelet of pedal rod, then remove boot.
• Remove nut, bracket and bolts, then separate cover from housing.
• Remove piston assembly and seals.
• Remove spool valve, then the accu...