2006 Chevrolet Suburban 2500 Brake Service (ONLINE REPAIR MANUALS)

Delco Master Cylinder

When performing the following procedures, refer to Figs. and , noting that the composite reservoir may vary in design.

Disassemble

• Remove master cylinder from vehicle.
• Remove reservoir cover and diaphragm. Discard old brake fluid in reservoir.
• Inspect cover and diaphragm. Replace if cut, cracked or deformed.
• Remove fluid level switch and proportioning valve assembly, if equipped.
• Depress primary piston and remove lock ring.
• Plug primary fluid outlet (outlet nearest to cowl when master cylinder is installed), then apply compressed air into secondary fluid outlet ...

In order to properly service power brake systems, a thorough understanding of the various power assist systems is required. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort required to obtain acceptable stopping performance. Two basic types of power assist mechanisms are used: vacuum assist diaphragm assemblies which use engine vacuum and in some cases vacuum from an external vacuum pump, and hydraulic assist assemblies which use hydraulic pressure developed by an external pump (us...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, on models with hydraulic assist brakes, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brak...

The caliper mounts in a way that allows the caliper to move laterally inboard as the brake pads wear. The caliper housing is a one piece casting with the inboard side containing the piston bore. The piston seal also acts as a return mechanism for the piston.

Applying the brake pedal causes the hydraulic pressure that moves the caliper piston. The piston then forces the inboard brake pad against the inboard braking surface of the rotor. Increasing the force against...

Brake Lines & Linings

Remove one of the front wheels and inspect the brake disc, caliper and linings.

Do not allow any oil or grease on the linings. It is recommended that linings be replaced in sets when worn or damaged.

If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.

Brake Roughness

The most common cause of brake chatter on disc brakes is a variation in thickness of the disc. If roughness or vibration is encountered during highway operation or if pedal pumping is experienced at low speeds, the disc may have excessive thickness v...