2007 Buick Terraza Brake Service (ONLINE REPAIR MANUALS)

Height Sensing Proportioning Valve

The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be inspected if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.

• Raise and support vehicle, leave wheels on and allow axle to hang freely.
• Remove lever retaining nut and disconnect lever from valve shaft, Fig. .
• Rotate valve shaft to permit installation of correct adjustment gauge, Fig. , ensure D shaped hol...

Brake System Bleed

ABS Automated Bleed

In most circumstances a base brake bleed is all that is required for most component replacements (such as wheel cylinders, calipers, brake tubes, and master cylinder) except for BPMV replacement.

The following automated ABS bleed procedure is required when one of the following occur: Manual bleeding at the wheel cylinders does not achieve the desired pedal height or feel. Brake Pressure Modulator Valve replacement (BPMV). Extreme loss of brake fluid has occurred. Air ingestion is suspected.

If none of the above conditions apply use standard blee...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, on models with hydraulic assist brakes, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brak...

Removal

Front

• Siphon brake fluid out of master cylinder until fluid level is approximately ^1/3 full, this will prevent fluid overflow when caliper piston is pushed back into its bore.
• Raise and support vehicle, then remove wheels.
• Push piston back into its bore using suitable C-clamp, Fig. .
• Remove brake caliper hose bolt, then two metal gaskets from brake caliper bolt.
• Remove two caliper mounting bolts and lift caliper off of rotor.

Rear

• Siphon brake fluid out of master cylinder until fluid level is approximately ^1/3 full, this will prevent fluid overflow when caliper piston is pushed ...

Hybrid Battery Service

Disconnect

Before working on any high voltage system, be sure to wear the following Personal Protection Equipment: Safety glasses with appropriate side shields when within 50 feet of the vehicle, either indoors or outdoors. Certified and up-to-date Class "0" Insulation gloves rated at 1000 volts with leather protectors. Visually and functionally inspect the gloves before use. Wear the Insulation gloves at all times when working with the high voltage battery assembly, whether the system is energized or not. Failure to follow the procedure exactly as written may res...

Delco Master Cylinder

When performing the following procedures, refer to Fig. noting that the composite reservoir may vary in design.

Disassemble

• Remove master cylinder from vehicle.
• Remove reservoir cover and diaphragm. Discard old brake fluid in reservoir.
• Inspect cover and diaphragm. Replace if cut, cracked or deformed.
• Remove fluid level switch and proportioning valve assembly, if equipped.
• Depress primary piston and remove lock ring.
• Plug primary fluid outlet (outlet nearest to cowl when master cylinder is installed), then apply compressed air into secondary fluid outlet to remo...