Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2007 Hummer H3 car and truck
repair procedures including Hummer engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2007 Hummer H3 automobile. Try the Automotix DIY solution today!
We have info for following modifications of 2007 Hummer H3
- 2007 Hummer H3 3.7 L5 GAS, CC:3654, CID:223, Fuel Injection, Aspiration:223, Engine VIN:, Desg:E
- 2007 Hummer H3 X 3.7 L5 GAS, CC:3654, CID:223, Fuel Injection, Aspiration:223, Engine VIN:, Desg:E
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> Change Oil, Change Oil Now Or Change Oil Soon Lamp & Messages -> H3 -> Alternate Method -> Reset Stem Method
Vehicle: 2007 Hummer H3 3.7 L5 GAS
Reset Stem Method
- Turn ignition switch to RUN position, but do not start engine.
- Press and hold reset stem in the lower center of the instrument cluster until the Oil Life message is displayed.
- Once the alternating OIL LIFE and RESET messages appear in the display, press and hold the reset stem until several beeps sounds This confirms the oil life system has been reset.
- Turn ignition key to Lock position. If the CHANGE/OIL message comes back on when the engine is started, the engine oil life s...
CLICK HERE TO GET FULL ACCESS TO 2007 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> Air Cleaner Restriction Indicator ->
Vehicle: 2007 Hummer H3 X 3.7 L5 GAS
An air cleaner restriction indicator, Fig. , is located in the intake duct between the MAF sensor and the air cleaner assembly.
If the window shows green, no service is required at this time. However, if...
CLICK HERE TO GET FULL ACCESS TO 2007 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> All Wheel Drive (AWD) System Warning Lamp ->
Vehicle: 2007 Hummer H3 X 3.7 L5 GAS
This lamp should light for a approximately 6-8 seconds when the ignition is turned On as a bulb check. If the war...
CLICK HERE TO GET FULL ACCESS TO 2007 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> Check Engine/Service Engine Soon Indicator Lamp -> Electronic Engine Controls Or Electronic Fuel Injection Except Tracker
Vehicle: 2007 Hummer H3 3.7 L5 GAS
The Check Engine/Service Engine Soon Lamp should light when the ignition is turned On. When the engine is started, the lamp should go off. If the lamp remains on for 10 seconds or constantly after the engine is started, the self diagnosis system has detected a problem and has stored a code in the system Electronic Control Module (ECM) or Powertrain Control Module (PCM). After diagnosis and repair, the ECM/PCM memory can be cleared of codes either by using a scan tool (OBD II systems) or by disconnecting the battery ground ca...
CLICK HERE TO GET FULL ACCESS TO 2007 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> All Wheel Drive (AWD) System Warning Lamp ->
Vehicle: 2007 Hummer H3 3.7 L5 GAS
This lamp should light for a approximately 6-8 seconds when the ignition is turned On as a bulb check. If the war...
CLICK HERE TO GET FULL ACCESS TO 2007 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> Low Coolant Lamp ->
Vehicle: 2007 Hummer H3 X 3.7 L5 GAS
This lamp should light when engine coolant level in the radiator drops below a predetermined le...
CLICK HERE TO GET FULL ACCESS TO 2007 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
