2008 Audi S8 Driveline U-Joint & CV Axles Replacement

Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!

Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2008 Audi S8 car and truck repair procedures including Audi engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up & drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix your 2008 Audi S8 automobile. Try the Automotix DIY solution today!

DIY REPAIR SAMPLES > CONTINUE EXPLORING >

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2008 Audi S8 AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2008 Audi S8 cars and light trucks from 1990+.

CV AXLE SHAFT, Replace -> Front -> Rear
Vehicle: 2008 Audi S8 5.2 V10 GAS

Front

Remove wheel trim. Detach trim cap for light-alloy wheels using puller in vehicle tool kit.
Loosen driveshaft collar bolt only 90°, so as to not damage wheel bearing. Vehicle must be standing on its wheels when loosening and tightening collar bolt to reduce risk of accident.
Remove wheel and tire assembly.
Screw in all five wheel bolts hand-tight.
With an assistant applying the brakes, remove driveshaft collar bolt from the driveshaft. If collar bolt is loose or has been removed, wheel bearings must not be loaded. If wheel bearings are loaded with weight of vehicle, whee...

CLICK HERE TO GET FULL ACCESS TO 2008 Audi S8 DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2008 Audi S8 AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2008 Audi S8 cars and light trucks from 1990+.

DRIVESHAFT, Replace
Vehicle: 2008 Audi S8 5.2 V10 GAS

Raise and support vehicle.
Disconnect both tunnel struts.
Remove rear section of exhaust system at exhaust pipe clamp(s).
Unbolt heat shield for center bearing.
Remove bolts and take off cover.
Remove nuts securing front mufflers and tie up or support front mufflers. Avoid excessive bending of flexible pipe connection (decoupling element) on front exhaust pipe. Angle between front muffler and front exhaust pipe must not exceed 10° or flexible connection will be damaged.
Remove bolts and remove heat shield from transmission.
Check whether there is a factory marking (paint) on drives...

CLICK HERE TO GET FULL ACCESS TO 2008 Audi S8 DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

Shop online for auto body parts, engines, wheels, lights...

More parts

Auto Repair Quick Search

Help me find

Search DIY repair manuals by VIN...

Get the Complete Technical Service Bulletins!

Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2008 Audi S8 vehicle.