2008 Cadillac Escalade Brake Service (ONLINE REPAIR MANUALS)

Brake System Bleed

ABS Automated Bleed

The base hydraulic brake system must be bled before performing this automated bleeding procedure.

• Connect a suitable scan tool to Data Link Connector (DLC).
• Start engine and allow engine to idle.
• Follow instructions on scan tool to access automated bleed procedure.
• Apply brake pedal when instructed by scan tool.
• Turn ignition off and remove scan tool from vehicle.
• Fill brake master cylinder reservoir to maximum fill level with brake fluid from a clean, sealed brake fluid container.
• Bleed hydraulic brake system as outlined under "Hydraulic Brake System... "

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, on models with hydraulic assist brakes, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brak...

Hybrid Battery Service

Disconnect

Before working on any high voltage system, be sure to wear the following Personal Protection Equipment: Safety glasses with appropriate side shields when within 50 feet of the vehicle, either indoors or outdoors. Certified and up-to-date Class "0" Insulation gloves rated at 1000 volts with leather protectors. Visually and functionally inspect the gloves before use. Wear the Insulation gloves at all times when working with the high voltage battery assembly, whether the system is energized or not. Failure to follow the procedure exactly as written may res...

Height Sensing Proportioning Valve

The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be inspected if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.

• Raise and support vehicle, leave wheels on and allow axle to hang freely.
• Remove lever retaining nut and disconnect lever from valve shaft, Fig. .
• Rotate valve shaft to permit installation of correct adjustment gauge, Fig. , ensure D shaped hol...

Removal

• Siphon ^2/3 of the brake fluid from master cylinder.
• Raise and support vehicle.
• Remove tire and wheel assembly.
• Compress caliper pistons until they bottom in bores using suitable clamp, Fig. .
• Disconnect brake hose at caliper by removing inlet fitting bolt.
• Remove mounting bolts and caliper.

Inspection

Should it become required to remove the caliper for installation of new components, clean components in denatured alcohol, wipe dry using lint-free cloths. Blow out drilled passages and holes using compressed air. Inspect dust boots for punctures or tears. If punctures or tears are...

Brake Lines & Linings

Remove one of the front wheels and inspect the brake disc, caliper and linings.

Do not allow any oil or grease on the linings. It is recommended that linings be replaced in sets when worn or damaged.

If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.

Brake Roughness

The most common cause of brake chatter on disc brakes is a variation in thickness of the disc. If roughness or vibration is encountered during highway operation or if pedal pumping is experienced at low speeds, the disc may have excessive thickness v...