Auto Parts Search
We have info for following modifications of 2008 Hummer H3
- 2008 Hummer H3 X 3.7 L5 GAS, CC:3654, CID:223, Fuel Injection, Aspiration:223, Engine VIN:, Desg:E
- 2008 Hummer H3 3.7 L5 GAS, CC:3654, CID:223, Fuel Injection, Aspiration:223, Engine VIN:, Desg:E
- 2008 Hummer H3 Alpha 5.3 V8 GAS, CC:5328, CID:325, Fuel Injection, Aspiration:325, Engine VIN:, Desg:L
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> Check Engine Oil Level ->
Vehicle: 2008 Hummer H3 3.7 L5 GAS
This system is used to indicate a low engine oil level condition. The lamp should light during engine starting. If oil level is sufficient, the lamp should go off when engine is operating. If oil level is low the...
CLICK HERE TO GET FULL ACCESS TO 2008 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> Low Coolant Lamp ->
Vehicle: 2008 Hummer H3 3.7 L5 GAS
This lamp should light when engine coolant level in the radiator drops below a predetermined le...
CLICK HERE TO GET FULL ACCESS TO 2008 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> Change Trans Fluid Indicator ->
Vehicle: 2008 Hummer H3 Alpha 5.3 V8 GAS
This message will appear on the DIC (Driver Information Center) when it is time to change the transmission fluid....
CLICK HERE TO GET FULL ACCESS TO 2008 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> Service Throttle Soon Indicator Lamp ->
Vehicle: 2008 Hummer H3 X 3.7 L5 GAS
A "Service Throttle Soon" indicator lamp is mounted in the lower righthand instrument cluster corner on these models. It lights when the ignition is turned On, but should go out approximately 1-5 seconds after the engine starts.
Traditional throttle cables are no longer used on these models. The PCM receives signals from an electron...
CLICK HERE TO GET FULL ACCESS TO 2008 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> Tire Pressure Monitoring System (TPMS) Warning Indicator -> 2008-09 H3 -> Relearn -> Reset
Vehicle: 2008 Hummer H3 3.7 L5 GAS
Reset
When the Tire Pressure Monitor system detects a significant loss of tire pressure, the CHECK TIRE PRESSURE message is displayed on the DIC and the low tire pressure indicator is displayed on the instrument panel cluster. Adjusting tire to recommended pressure and driving the vehicle at a speed above 25 mph for at least 2 minutes will clear the tire message.
Relearn
- Apply the Parking brake, then place the ignition switch in the On position.
- Cycle the headlamp switch from Off to Parking Lamp position 4 times within 4 seconds.
- The horn should chirp twice and the low tire pressure warni...
CLICK HERE TO GET FULL ACCESS TO 2008 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Hummer H3 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Hummer H3 cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> Check Engine/Service Engine Soon Indicator Lamp -> Electronic Engine Controls Or Electronic Fuel Injection Except Tracker
Vehicle: 2008 Hummer H3 3.7 L5 GAS
The Check Engine/Service Engine Soon Lamp should light when the ignition is turned On. When the engine is started, the lamp should go off. If the lamp remains on for 10 seconds or constantly after the engine is started, the self diagnosis system has detected a problem and has stored a code in the system Electronic Control Module (ECM) or Powertrain Control Module (PCM). After diagnosis and repair, the ECM/PCM memory can be cleared of codes either by using a scan tool (OBD II systems) or by disconnecting the battery ground ca...
CLICK HERE TO GET FULL ACCESS TO 2008 Hummer H3 MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2008 Hummer H3 vehicle. |
Access the Complete guide! |