1990 Chevrolet V2500 Suburban Brake Service (ONLINE REPAIR MANUALS)

DESCRIPTION

The Hydro-Boost system, Fig. , provides an additional cylinder in the brake system. This cylinder contains no brake fluid. The Hydro-Boost cylinder is hydraulically operated, by pressurized fluid from the power steering pump, providing power assist to operate a dual master cylinder brake system.

The booster is composed of two sections; the linkage section and the power section.

The booster is designed so that if a total absence of power assist occurs, the brakes can be applied manually, but somewhat greater pressure on the brake pedal is required.

DISASSEMBLE

• Place accumulato...

CABALLERO & EL CAMINO

Pump brake pedal several times with engine off to deplete accumulator of fluid.

• Remove two nuts attaching master cylinder to booster, then move master cylinder away from booster with brake lines attached.
• Remove three hydraulic lines from booster. Plug and cap all lines and outlets.
• Remove retainer and washer securing booster pushrod to brake pedal arm.
• Remove four nuts attaching booster unit to dash panel.
• From engine compartment, loosen booster from dash panel and move booster pushrod inboard until it disconnects from brake pedal arm. Remove spring wa...

BLEEDING EHCU MODULE

The EHCU Module should be bled after replacement or if trapped air is in the unit. If bleeding is required the module must be bled thoroughly before the wheel cylinders and calipers.

There are two bleeders on top of the unit that appear to be normal bleeders, Fig. . These are modulator bleeders and must remain closed when the unit is not pressurized.

The internal bleeders are on either side of EHCU module. The valves are used to open the internal passages within the EHCU module. Both bleed valves must be rotated ^1/4-^1/2 a turn counterclockwise before beginning t...

REMOVAL

• Siphon enough brake fluid out of the master cylinder to bring fluid level to^1-3 full to avoid fluid overflow when the caliper piston is pushed back into its bore.
• Raise and support vehicle, remove front wheels.
• Using a C-clamp, as illustrated in Fig. , push piston back into its bore.
• Remove two mounting bolts and lift caliper away from disc.

DISASSEMBLE

• Disconnect hose from the caliper being careful not to lose copper washers.
• Remove caliper as outlined above.
• Drain brake fluid from caliper.
• Pad caliper interior with clean shop towels and apply compressed air to remove piston, Fi...

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level due to a chemical breakdown during use, and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent e...

This unit, Fig. , uses a single vacuum diaphragm with an effective diameter of 7 inches to mechanically increase brake application force with engine vacuum...