Auto Parts Search

We have info for following modifications of 1990 Subaru Legacy
- 1990 Subaru Legacy 2.2 H4 GAS, CC:2212, Fuel Injection, Engine VIN:, Desg:6
- 1990 Subaru Legacy L 2.2 H4 GAS, CC:2212, Fuel Injection, Engine VIN:, Desg:6
- 1990 Subaru Legacy LS 2.2 H4 GAS, CC:2212, Fuel Injection, Engine VIN:, Desg:6
BRAKE SERVICE PROCEDURES FOR 1990 Subaru Legacy AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Subaru Legacy cars and light trucks from 1990+.
SUBARU, POWER BRAKE UNITS -> BRAKE BOOSTER REPLACEMENT -> EXCEPT SVX -> SVX
Vehicle: 1990 Subaru Legacy 2.2 H4 GAS
EXCEPT SVX
- Disconnect brake fluid level indicator connector, if equipped.
- Remove master cylinder assembly.
- Disconnect vacuum hose from brake booster.
- Working from inside the passenger compartment, remove snap pin and operating rod clevis pin from brake pedal assembly.
- Remove brake booster retaining nuts, then brake booster from vehicle.
- Reverse procedure to install. Torque brake booster retaining nuts to 9-17 ft. lbs.
SVX
- Disconnect battery ground cable.
- R...
CLICK HERE TO GET FULL ACCESS TO 1990 Subaru Legacy BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1990 Subaru Legacy AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Subaru Legacy cars and light trucks from 1990+.
SUBARU, ANTI-LOCK BRAKES -> DIAGNOSIS -> DIAGNOSTIC TESTS
Vehicle: 1990 Subaru Legacy LS 2.2 H4 GAS
To perform self diagnosis, drive vehicle at a speed greater than 20 mph for at least one minute. If system is malfunctioning, a warning lamp on the dash panel will come On. Approximately ten seconds after the light comes on, an L.E.D. located on the ABS control unit displays a trouble code. This trouble code is determined by the number of flashes the L.E.D. emits. To read codes, vehicle must remain running. Read ...
[[table data]]CLICK HERE TO GET FULL ACCESS TO 1990 Subaru Legacy BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1990 Subaru Legacy AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Subaru Legacy cars and light trucks from 1990+.
SUBARU, HYDRAULIC BRAKE SYSTEMS -> MASTER CYLINDER SERVICE
Vehicle: 1990 Subaru Legacy LS 2.2 H4 GAS
- Remove master cylinder from vehicle.
- Remove secondary piston stopper screw with screwdriver as shown in Fig. .
- Push piston inward, then remove snap ring.
- Apply pressure to piston assembly while Inserting a small screwdriver into window of piston retainer and raise piston retainer latch as shown in Fig. .
- Remove primary and secondary piston assemblies. Do not disassemble pistons. if disassembled, the spring settings will change.
- Inspect master cylinder inside diameter to piston clearance, Service limit is not to exceed 0.043 inch.
- Clean all parts...
CLICK HERE TO GET FULL ACCESS TO 1990 Subaru Legacy BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1990 Subaru Legacy AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Subaru Legacy cars and light trucks from 1990+.
SUBARU, DRUM BRAKES -> DRUM BRAKE ADJUSTMENT
Vehicle: 1990 Subaru Legacy LS 2.2 H4 GAS
On Justy, brake shoe clearances are automatically adjusted by pumping brake pedal several times as required.
On all models except Justy, loosen locknut of wedge adjuster and t...
CLICK HERE TO GET FULL ACCESS TO 1990 Subaru Legacy BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1990 Subaru Legacy AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Subaru Legacy cars and light trucks from 1990+.
SUBARU, DRUM BRAKES -> TIGHTENING SPECIFICATIONS
Vehicle: 1990 Subaru Legacy LS 2.2 H4 GAS
CLICK HERE TO GET FULL ACCESS TO 1990 Subaru Legacy BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1990 Subaru Legacy AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Subaru Legacy cars and light trucks from 1990+.
SUBARU, ANTI-LOCK BRAKES -> DIAGNOSIS -> DIAGNOSTIC TESTS
Vehicle: 1990 Subaru Legacy L 2.2 H4 GAS
To perform self diagnosis, drive vehicle at a speed greater than 20 mph for at least one minute. If system is malfunctioning, a warning lamp on the dash panel will come On. Approximately ten seconds after the light comes on, an L.E.D. located on the ABS control unit displays a trouble code. This trouble code is determined by the number of flashes the L.E.D. emits. To read codes, vehicle must remain running. Read ...
[[table data]]CLICK HERE TO GET FULL ACCESS TO 1990 Subaru Legacy BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |