Auto Parts Search
We have info for following modifications of 1990 Volvo 760
- 1990 Volvo 760 GLE 2.8 V6 GAS, CC:2849, Fuel Injection, Engine VIN:, Desg:6
- 1990 Volvo 760 2.3 L4 GAS, CC:2316, Fuel Injection, Engine VIN:, Desg:8
BRAKE SERVICE PROCEDURES FOR 1990 Volvo 760 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Volvo 760 cars and light trucks from 1990+.
VOLVO, HYDRAULIC BRAKE SYSTEMS -> SYSTEM SERVICE -> Assembly -> Clean & Inspect -> Disassembly -> MASTER CYLINDER OVERHAUL -> MASTER CYLINDER, REPLACE -> PRESSURE DIFFERENTIAL WARNING VALVE, REPLACE -> REGULATING VALVE, REPLACE
Vehicle: 1990 Volvo 760 2.3 L4 GAS
MASTER CYLINDER, REPLACE
- Place a cover over the fender to protect paint from brake fluid.
- Disconnect brake lines and cap openings.
- Remove retaining nuts, then the master cylinder.
- Reverse procedure to install. Bleed master cylinder prior to installation.
MASTER CYLINDER OVERHAUL
Disassembly
- Remove reservoir from master cylinder.
- Drain fluid from reservoir, then remove seals.
- Remove circlip and withdraw pistons and return spring.
Clean & Inspect
- Polish inner surface of the master cylinder with a honing tool (cylinder grinding tool).
- Clean all pistons parts and cylinder with methylated spirits...
CLICK HERE TO GET FULL ACCESS TO 1990 Volvo 760 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1990 Volvo 760 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Volvo 760 cars and light trucks from 1990+.
VOLVO, DISC BRAKES -> FRONT DISC BRAKE SERVICE -> 240 Series -> 740, 760, 780, 940 & 960 Series -> BRAKE PADS, REPLACE -> CALIPER REMOVAL & OVERHAUL
Vehicle: 1990 Volvo 760 GLE 2.8 V6 GAS
BRAKE PADS, REPLACE
240 Series
- Raise car and remove wheels.
- Remove hairpin shaped locking clips for guide pins. Tap out one of guide pins while holding damper springs in place. Remove springs and other guide pin.
- Pull out pads using puller tool No. 2917 or equivalent.
- Carefully clean out cavity in which pads are located. Replace any dust covers that are damaged. If dirt has penetrated into cylinder due to a damaged cover, recondition brake caliper. Check brake disc and resurface if necessary.
- Press caliper pistons back into their bores with press tool No 2809 or a suitable wi...
CLICK HERE TO GET FULL ACCESS TO 1990 Volvo 760 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1990 Volvo 760 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Volvo 760 cars and light trucks from 1990+.
VOLVO, ANTI-LOCK BRAKES -> DESCRIPTION
Vehicle: 1990 Volvo 760 2.3 L4 GAS
The Anti-Lock Brake System (ABS) uses a control unit, hydraulic modulator, transient surge protector, front speed sensors and a speedometer sensor to control wheel lock-up. The control unit receives vehicle speed, wheel speed and wheel acceleration information from the sensors, then sends the information to the hydraulic modulator. The hydraulic modulator uses this information to ensure correct hydraulic pre...
CLICK HERE TO GET FULL ACCESS TO 1990 Volvo 760 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1990 Volvo 760 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Volvo 760 cars and light trucks from 1990+.
VOLVO, ANTI-LOCK BRAKES -> DIAGNOSIS & TESTING -> COMPONENT FAULT TRACING
Vehicle: 1990 Volvo 760 GLE 2.8 V6 GAS
The control unit contains a monitoring circuit to detect any internal faults in the control unit and any electrical faults in the sensors, hydraulic modulator or signaling system.
If a fault occurs, the control unit disengages the ABS and illuminates a warning light. When the warning light comes on, a complete fault tracing procedure should be followed. The fault tracing procedure assumes that the standard braking system is fully operational.
COMPONENT FAULT TRACING
All procedures must be completed to avoid damaging the control unit.
Refer to Figs through when performing the f...
CLICK HERE TO GET FULL ACCESS TO 1990 Volvo 760 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1990 Volvo 760 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Volvo 760 cars and light trucks from 1990+.
VOLVO, HYDRAULIC BRAKE SYSTEMS -> DESCRIPTION
Vehicle: 1990 Volvo 760 2.3 L4 GAS
The function of hydraulic brake system is to transmit pressure from the master cylinder to caliper pistons. The system will operate properly if fluid is tight and brake fluid cannot be compressed. Normally, brake fluid cannot be compressed. If however the fluid overheats sufficiently it can partially change to a vapor form. Vapor can be compressed and since the master cylinder has a specific volume with which to build up pressure, the compression of vapor can result in excess brake pedal travel before the system has time to develop adequate braking pressure.
Brake fluid is h...
CLICK HERE TO GET FULL ACCESS TO 1990 Volvo 760 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1990 Volvo 760 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1990 Volvo 760 cars and light trucks from 1990+.
VOLVO, DISC BRAKES -> PARKING BRAKE ADJUSTMENT
Vehicle: 1990 Volvo 760 GLE 2.8 V6 GAS
- Remove rear ashtray.
- Working through ashtray hole, tighten adjust...
CLICK HERE TO GET FULL ACCESS TO 1990 Volvo 760 BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1990 Volvo 760 vehicle. |
Access the Complete guide! |