Auto Parts Search

We have info for following modifications of 1992 Dodge Dakota
- 1992 Dodge Dakota 3.9 V6 GAS, CID:239, Fuel Injection, Aspiration:239, Engine VIN:, Desg:X
- 1992 Dodge Dakota 5.2 V8 GAS, CID:318, Fuel Injection, Aspiration:318, Engine VIN:, Desg:Y
- 1992 Dodge Dakota 2.5 L4 GAS, CC:2507, CID:153, Fuel Injection, Aspiration:153, Engine VIN:, Desg:G
BRAKE SERVICE PROCEDURES FOR 1992 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1992 Dodge Dakota cars and light trucks from 1990+.
Disc Brakes -> Dakota -> Caliper Service -> Assemble -> Disassemble -> Installation -> Removal
Vehicle: 1992 Dodge Dakota 3.9 V6 GAS
Removal
- Raise vehicle, then remove front wheel.
- On 2WD models, remove outboard brake pad hold down spring, Fig. .
- On all models, disconnect brake hose at caliper and discard fitting washers if worn or damaged.
- Remove caliper slide pins, then lift caliper and brake pads off rotor.
- If necessary, remove brake pads from caliper as outlined under "Brake Pad Service."
Disassemble
- Clean outside of caliper with suitable solvent.
- Drain fluid from caliper and place clean shop cloths in caliper opposite piston.
- Slowly apply compressed air to caliper inlet port until piston moves out of bore. Do not "b... "
CLICK HERE TO GET FULL ACCESS TO 1992 Dodge Dakota BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1992 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1992 Dodge Dakota cars and light trucks from 1990+.
Hydraulic Brake Systems -> Diagnosis & Testing -> Caravan, Town & Country & Voyager -> Chrysler -> Dakota -> Proportioning Valve
Vehicle: 1992 Dodge Dakota 5.2 V8 GAS
Chrysler
Proportioning Valve
Caravan, Town & Country & Voyager
These models use a proportioning valve and pressure differential switch, or a combination valve. When a premature rear wheel skid is obtained during braking, it may be an indication that fluid pressure to rear brakes is above a desired output and/or a malfunction has occurred within the valve. At this time, the valve unit should be tested as follows:
- Remove actuator assembly adjustment nut, Fig. , then disconnect assembly from valve lever and remove.
- Install gauge and Tee from line pressure set No. C-4007, or equivale...
CLICK HERE TO GET FULL ACCESS TO 1992 Dodge Dakota BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1992 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1992 Dodge Dakota cars and light trucks from 1990+.
Drum Brakes -> Chrysler -> Adjustments -> 1992-95 -> 1996 -> Adjustment -> Except FWD Models & Ram 50 -> FWD Models -> Parking Brake -> Ram 50 -> Self-Adjusting Brakes -> Service Brake
Vehicle: 1992 Dodge Dakota 3.9 V6 GAS
Service Brake
Except FWD Models & Ram 50
Self-Adjusting Brakes
These brakes have self-adjusting shoe mechanisms that ensure correct lining to drum clearances at all times. The automatic adjusters operate only when the brakes are applied as the car is moving rearward.
Although the brakes are self-adjusting, an initial adjustment is necessary when the brake shoes have been relined, replaced or when the length of the star wheel adjuster has been changed during some other service operation.
Frequent usage of an automatic transmission forward range to halt reverse vehicle motion may prevent t...
CLICK HERE TO GET FULL ACCESS TO 1992 Dodge Dakota BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1992 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1992 Dodge Dakota cars and light trucks from 1990+.
Disc Brakes -> Dakota -> Precautions -> Bleeding Brakes -> Brake Disc Service -> Brake Lines & Linings -> Brake Roughness -> Caliper Inspection -> General Precautions
Vehicle: 1992 Dodge Dakota 2.5 L4 GAS
Brake Lines & Linings
Remove one of the front wheels and inspect the brake disc, caliper and linings. The wheel bearings should be inspected at this time and repacked if necessary.
Do not get any oil or grease on the linings. It is recommended that both front wheel sets be replaced whenever a respective pad is worn or damaged. Inspect and, if necessary, replace rear brake linings also.
If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.
Brake Roughness
The most common cause of brake chatter on disc brakes is a variation in thickness o...
CLICK HERE TO GET FULL ACCESS TO 1992 Dodge Dakota BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1992 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1992 Dodge Dakota cars and light trucks from 1990+.
Drum Brakes -> Chrysler -> Tightening Specifications
Vehicle: 1992 Dodge Dakota 2.5 L4 GAS
CLICK HERE TO GET FULL ACCESS TO 1992 Dodge Dakota BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1992 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1992 Dodge Dakota cars and light trucks from 1990+.
Power Brake Units -> Power Brake Unit Service -> 1992 -> 1992-95 -> 1993-96 -> 1996 -> Caravan, Town & Country & Voyager -> Cherokee & Comanche -> Dakota -> Full Size Pickups & Vans -> Grand Cherokee -> Inline Mount -> Ram 50 -> Replacement -> Transverse Mount -> Wrangler
Vehicle: 1992 Dodge Dakota 3.9 V6 GAS
The only serviceable power brake booster components are the vacuum hose and the check valve. The power brake booster must be serviced as an assembly. If diagnosis indicates a power brake booster fault, the unit must be replaced as an assembly.
Replacement
Full Size Pickups & Vans
1992
Transverse Mount
- Disconnect vacuum hose from power booster.
- Remove master cylinder to booster attaching nuts, then the master cylinder.
- Remove booster pushrod to pivot attaching bolts.
- Remove power booster attaching nuts, then the power booster assembly.
- Reverse procedure to install.
Inline Mount
- Dis...
CLICK HERE TO GET FULL ACCESS TO 1992 Dodge Dakota BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |