1993 GMC G25/G2500 VAN Brake Service (ONLINE REPAIR MANUALS)

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level due to a chemical breakdown during use, and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent exces...

Manual Bleed

• If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
• Fill master cylinder reservoirs with suitable brake fluid. Be sure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
• If master cylinder is suspected to have air in the bore, it must be bled first, as follows:
• Disconnect forward brake pipe connection at master cylinder.
• Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
• Connect and tighten forward brake pipe at...

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level due to a chemical breakdown during use, and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent exces...

Disassemble

• Place accumulator compressor tool No. J-26889 or equivalent, around end of accumulator.
• Install nut onto stud as shown in Fig. , then depress the accumulator with a C-clamp.
• Remove retainer by using a punch.
• Release C-clamp and remove accumulator compressor tool.
• Remove accumulator, O-ring, retainer, plug and spring, Fig. .
• Remove retainer, output pushrod, baffle, piston return spring and retainer.
• Using a suitable saw, cut off eyelet of pedal rod, then remove the boot.
• Remove nut, bracket and bolts, then separate cover from housing.
• Remove piston assembly and seals...

The Bendix single piston sliding caliper disc brake is standard equipment on some truck applications, while on other trucks it is used only in Hydro-Boost power brake applications with both front disc brakes and 4 wheel disc brakes. On 4 wheel disc brakes, the front and rear systems are identical.

T...

1992

The Rear Wheel Anti-Lock (RWAL) system, Fig. , reduces the occurrence of rear wheel lockup during severe braking by regulating rear hydraulic line pressure. Pressure applied to the rear wheel brakes is regulated by a control valve assembly located under the master cylinder. The control valve consists of a dump valve which releases hydraulic pressure into an accumulator, and an isolation valve which holds rear brake pressure. Operation of the dump valve and isolation valve is controlled by an Electronic Control Unit (ECU) which is mounted next to the master cylinder.

The ECU rec...