Auto Parts Search
BRAKE SERVICE PROCEDURES FOR 1994 BMW 318IS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1994 BMW 318IS cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> 318 & 325 -> 735, 750 & 850 -> Brake Force Regulator, Replace -> Master Cylinder, Replace -> Power Flow Regulator, Replace
Vehicle: 1994 BMW 318IS 1.8 L4 GAS
Master Cylinder, Replace
- Remove brake fluid from master cylinder with a syringe.
- Remove plug and clutch hose if equipped.
- Remove fluid reservoir.
- Remove brake lines, then mounting bolts.
- Remove master cylinder.
- Reverse procedure to install and bleed brake system.
Power Flow Regulator, Replace
735, 750 & 850
- With engine off, discharge hydraulic reservoir by operating brake pedal approximately 20 times with same force required for full stop braking action.
- Disconnect electri...
CLICK HERE TO GET FULL ACCESS TO 1994 BMW 318IS BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1994 BMW 318IS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1994 BMW 318IS cars and light trucks from 1990+.
Anti-lock Brakes -> Diagnosis & Testing -> 318 and 325 -> 525, 535, 735 & 750 -> Diagnostic Tests
Vehicle: 1994 BMW 318IS 1.8 L4 GAS
The electronic control unit monitors the Anti-Lock Brake System (ABS) constantly. The system must be checked when the ABS indicator lamp does not go out, comes on while driving or does not come on when ignition is turned on. A BMW service tester ...
[[table data]] [[table data]]CLICK HERE TO GET FULL ACCESS TO 1994 BMW 318IS BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1994 BMW 318IS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1994 BMW 318IS cars and light trucks from 1990+.
Power Brake Units -> Diagnosis & Testing -> 318, 325, 525 & 535 -> Brake Booster Vacuum Supply Check -> Function Test
Vehicle: 1994 BMW 318IS 1.8 L4 GAS
Function Test
- Operate brake pedal ten times with engine stopped.
- If brake pedal gives, system is okay.
- If brake pedal does not give, check valve, vacuum hose and/or rubber ring between master cylinder and brake booster could be defective.
Brake Booster Vacuum Supply Check
318, 325...
CLICK HERE TO GET FULL ACCESS TO 1994 BMW 318IS BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1994 BMW 318IS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1994 BMW 318IS cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed
Vehicle: 1994 BMW 318IS 1.8 L4 GAS
- Connect suitable pressure bleeder to brake fluid reservoir. Maximum charging pressure is 43.5 psi.
- Attach bleeder hose and container to right rear wheel. Bleed until no bubbles appear.
- Repeat step 2 for left rear, right front and left front wheels.
- Support rear suspension at wheel carriers and lower car so rear suspension compresses to its normal loaded position (to prevent damage to output shaft joints). Wheels must be able to turn freely.
- Attach...
CLICK HERE TO GET FULL ACCESS TO 1994 BMW 318IS BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1994 BMW 318IS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1994 BMW 318IS cars and light trucks from 1990+.
Power Brake Units -> Power Brake Unit Service -> 318, 325, 525 & 535 -> 735, 750 & 850 -> Power Brake Booster, Replace
Vehicle: 1994 BMW 318IS 1.8 L4 GAS
Power Brake Booster, Replace
318, 325, 525 & 535
- Remove master cylinder from booster.
- Remove lower left trim panel.
- Disconnect bayonet pin and clip from booster pushrod, below instrument panel. Fig. .
- Detach booster from pedal base. Remove booster from engine compartment.
- Reverse procedure to install.
735, 750 & 850
- With engine off, discharge hydraulic reservoir by operating brake pedal approximately 20 times with same force required for ful...
CLICK HERE TO GET FULL ACCESS TO 1994 BMW 318IS BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1994 BMW 318IS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1994 BMW 318IS cars and light trucks from 1990+.
Hydraulic Brake Systems -> Description -> 735 & 750 -> 850 -> H-31 Hydraulic System -> Master Cylinder
Vehicle: 1994 BMW 318IS 1.8 L4 GAS
H-31 Hydraulic System
The H-31 hydraulic system, Fig. , incorporates a power flow regulator which diverts a small flow of fluid from the power steering operating circuit for the power assisted brake system. It charges the hydraulic reservoir in a high pressure range without impairing the function of power steering. The pressurized hydraulic oil volume is supplied to the booster for the sake of power assistance and is applied by operating the connected standard tandem master cylinder. should the power steering pump fail, the hydraulic reservoir has sufficient reserve pressure to permi...
CLICK HERE TO GET FULL ACCESS TO 1994 BMW 318IS BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1994 BMW 318IS vehicle. |
Access the Complete guide! |