Auto Parts Search
1995 GMC Yukon CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT GMC REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Component Locations
- Wiring Diagrams
- Technical Service Bulletins
- Specifications
- A/C & Heater Service
- Brake Service
- Fuel Filter Replacement
- Driveline, U-Joint & CV Axles Replacement
- Starter & Alternator Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
A/C & HEATER SERVICE PROCEDURES FOR 1995 GMC Yukon AUTOMOBILES
Air Bag System Precautions -> General Motors Corp. -> Arming -> Light Trucks & Vans -> Passenger Cars
Vehicle: 1995 GMC Yukon 6.5 V8 DIESEL
Passenger Cars
Reverse disarming procedures to arm the Supplemental Restraint System, noting the following:
- Ensure all disconnected SRS electrical connectors are securely connected and routed.
- Install all removed fuses in proper locations.
- From a safe position at sides of or below air bag module, Turn ignition switch to ON position and observe Air Bag or SRS warning lamp.
- On all models except Prizm and 1990 Corvette, warning lamp should flash seven to nine times, then go off.
- On Prizm models, warning lamp should light for six seconds,...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon A/C & HEATER SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 GMC Yukon AUTOMOBILES
Anti-lock Brakes -> Rear Wheel Anti-Lock Brake System -> System Service -> 1992 -> 1993-95 -> Anti-Lock Pressure Valve (APV) -> Brake System Bleed -> C & K Series -> Component Replacement -> Electronic Brake Control Module (EBCM) -> Electronic Control Unit (ECU) -> Isolation/Dump Valve Assembly -> Manual Bleeding -> Pressure Bleeding -> Vehicle Control Module (VCM) -> Vehicle Speed Sensor
Vehicle: 1995 GMC Yukon 5.7 V8 GAS
Brake System Bleed
1992
Before bleeding the brakes, the front and rear displacement cylinder pistons must be returned to the top most position. Using a TECH 1 or equivalent scan tool, enter manual control function and apply the front and rear motors. Ensure enable relay is on.
Use only DOT 3 brake fluid from a clean and sealed container. Do not use DOT 5 brake fluid.
Pressure Bleeding
- Remove master cylinder cover, ensure reservoir is properly filled.
- Connect bleeder adapter tool No. J 35589, or equivalent, to master cylinder reservoir.
- Connect bleeder adapter to pressure bleeding equipm...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon BRAKE SERVICE PROCEDURES
FUEL FILTER REPLACEMENT PROCEDURES FOR 1995 GMC Yukon AUTOMOBILES
General Motors Corp./Saturn Light Trucks, SUVs & Vans -> Fuel Filter Replacement -> 6.5L Diesel Engine
Vehicle: 1995 GMC Yukon 6.5 V8 DIESEL
On models equipped with fuel injected engines, relieve fuel system pressure as outlined under "Fuel System Pressure Relief."
On models equipped with metal collar quick disconnect connectors, GM tool No. J37088-A, or equivalent, will be required to disconnect the connector. Prior to reconnecting the connector, apply a few drops of clean motor oil to the male pipe ends.
On models equipped with plastic collar quick disconnect connectors, squeeze the connector plastic retainer release tabs to release the connector. Prior to reconnecting the connector, apply a few drops of clean motor...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon FUEL FILTER REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1995 GMC Yukon AUTOMOBILES
DRIVESHAFT, Replace -> Front -> Front, All Except NP8 Axle -> Front, NP8 Axle -> One Piece Driveshaft -> Rear -> Three Piece Driveshaft -> Two Piece Driveshaft
Vehicle: 1995 GMC Yukon 6.5 V8 DIESEL
Front
Front, All Except NP8 Axle
- Raise and support vehicle.
- Remove front differential carrier shield, if used.
- Reference mark relationship of propeller shaft to front axle and transfer case flange.
- Remove bolts and retainers from front axle.
- Remove bolts and retainers from transfer case.
- Remove propeller shaft. When removing propeller shaft, do not attempt to remove shaft by pounding on yoke ears or using a tool between yoke and universal joint. If propeller shaft is removed by using such means, injection joints may fracture and lead to premature failure of joint.
- Compress propeller...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 1995 GMC Yukon AUTOMOBILES
Starter, Replace
Vehicle: 1995 GMC Yukon 6.5 V8 DIESEL
- Disconnect battery ground cable.
- Raise and support vehicle.
- Remove starter to engine brace and heat shields, if equipped.
- Remove starter motor mounting bolts and lower ...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon STARTER & ALTERNATOR REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1995 GMC Yukon AUTOMOBILES
General Motors Corp./Saturn Trucks -> Service Four Wheel Drive (4WD) System Warning Lamp ->
Vehicle: 1995 GMC Yukon 6.5 V8 DIESEL
This lamp should light for approximately 6-8 seconds when the ignition is turned On as a bulb check. If the ...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 1995 GMC Yukon AUTOMOBILES
Heater Hose, Replace -> Inlet -> Outlet
Vehicle: 1995 GMC Yukon 6.5 V8 DIESEL
Inlet
- Remove air cleaner.
- Drain cooling system into a suitable container.
- Remove heater hose support clamp bolt.
- Reposition heater core inlet hose clamp at engine.
- Remove hose from engine.
- Reposition heater hose inlet clamp at heater core.
- Remove heater inlet hose from heater core.
- Remove hose from vehicle.
- Reverse procedure to in...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 1995 GMC Yukon AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 1995 GMC Yukon 6.5 V8 DIESEL
- Rotate tensioner to release belt tension, using a 1/2 inch breaker bar with a 5/8 inch socket placed on tensioner pulley.
- Remove drive belt.
- Route b...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon SERPENTINE BELT SERVICE PROCEDURES
COMPONENT LOCATION DIAGRAMS FOR 1995 GMC Yukon AUTOMOBILES
Component location diagrams for most 1995 GMC Yukon cars and light trucks sold in the U.S. from 1990+.
Behind LH Side Of I/P Diagram for 1995 GMC Yukon 6.5 V8 DIESEL Components on diagram: |
Engine Compartment Components Diagram for 1995 GMC Yukon 5.7 V8 GAS Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon PARTS/COMPONENTS LOCATION DIAGRAMS!
WIRING DIAGRAMS FOR 1995 GMC Yukon AUTOMOBILES
OEM drawn wiring diagrams for most 1995 GMC Yukon cars and light trucks sold in the U.S.
1995 GMC Yukon 5.7 V8 GAS Wiring Diagram Components on diagram: |
1995 GMC Yukon 5.7 V8 GAS Wiring Diagram Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon WIRING DIAGRAMS!
TECHNICAL SERVICE BULLETINS FOR 1995 GMC Yukon AUTOMOBILES
OEM TSB listings for most 1995 GMC Yukon cars and light trucks sold in the U.S. from 1985+.
Document: New Website for AFIT, TPM, and VDR Updates Vehicle: 1995 GMC Yukon 5.7 V8 GAS Auto Systems: |
Document: Car and Truck Fix It Right the First Time Issues Vehicle: 1995 GMC Yukon 5.7 V8 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 1995 GMC Yukon AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 1995 GMC Yukon cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 1995 GMC Yukon cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 1995 GMC Yukon cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 1995 GMC Yukon cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Yukon SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1995 GMC Yukon vehicle. |
Access the Complete guide! |