Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 1997 Chevrolet Venture car and truck
repair procedures including Chevrolet engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 1997 Chevrolet Venture automobile. Try the Automotix DIY solution today!
BRAKE SERVICE PROCEDURES FOR 1997 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Chevrolet Venture cars and light trucks from 1990+.
Disc Brakes -> Delco Single Piston Sliding Caliper -> Caliper Service -> Assemble -> Blazer, Bravada & Jimmy -> Disassemble -> Front -> Inspection -> Installation -> Rear -> Removal -> Sierra & Silverado
Vehicle: 1997 Chevrolet Venture 3.4 V6 GAS
Removal
Front
- Siphon brake fluid out of master cylinder until fluid level is approximately 1/3 full, this will prevent fluid overflow when caliper piston is pushed back into its bore.
- Raise and support vehicle, then remove wheels.
- Push piston back into its bore using suitable C-clamp, Fig. .
- Remove two caliper mounting bolts and lift caliper off of rotor.
Rear
Blazer, Bravada & Jimmy
- Raise and support vehicle.
- Mark position of wheel to hub for installation reference.
- Remove wheel assembly.
- Remove mounting bolt and disconnect brake hose fitting from caliper. Discard gaskets and plug brake h...
CLICK HERE TO GET FULL ACCESS TO 1997 Chevrolet Venture BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Chevrolet Venture cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed -> Hydraulic System Flush -> Manual Bleed -> Master Cylinder Bleed -> Parking Brake Bleed -> Pressure Bleed
Vehicle: 1997 Chevrolet Venture 3.4 V6 GAS
Manual Bleed
- If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
- Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
- If master cylinder is suspected to have air in the bore, it must be bled first. To bleed master cylinder, proceed as follows:
- Disconnect forward brake pipe connection at master cylinder.
- Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
- Connect ...
CLICK HERE TO GET FULL ACCESS TO 1997 Chevrolet Venture BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Chevrolet Venture cars and light trucks from 1990+.
Disc Brakes -> Delco Single Piston Sliding Caliper -> Precautions -> Brake Disc Service -> Brake Lines & Linings -> Brake Roughness -> General
Vehicle: 1997 Chevrolet Venture 3.4 V6 GAS
Brake Lines & Linings
Remove one of the front wheels and inspect the brake disc, caliper and linings.
Do not allow any oil or grease on the linings. It is recommended that linings be replaced in sets when worn or damaged.
If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.
Brake Roughness
The most common cause of brake chatter on disc brakes is a variation in thickness of the disc. If roughness or vibration is encountered during highway operation or if pedal pumping is experienced at low speeds, the disc may have excessive thickness v...
CLICK HERE TO GET FULL ACCESS TO 1997 Chevrolet Venture BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Chevrolet Venture cars and light trucks from 1990+.
Disc Brakes -> Delco Single Piston Sliding Caliper -> Rotor Replacement -> 2WD Models -> 4WD Models -> Astro, Blazer, Bravada, Jimmy, K1500/2500 & T Series Pickup -> Except Montana, Silhouette, Trans Sport & Venture -> Front -> K3500 -> Montana, Silhouette, Trans Sport & Venture -> Rear
Vehicle: 1997 Chevrolet Venture 3.4 V6 GAS
2WD Models
Except Montana, Silhouette, Trans Sport & Venture
Front
- Raise and support vehicle.
- Remove tire and wheel assembly.
- Remove caliper as outlined under "Caliper Service."
- Remove grease cap from hub/rotor, Fig. .
- Remove cotter pin, nut and washer.
- Remove hub/rotor from spindle, being careful not to damage spindle threads or outer bearing.
- Reverse procedure to install, noting the following:
- Apply high-temperature wheel bearing grease to inner and outer wheel bearings.
- Torque nut to 12 ft. lbs. while turning wheel assembly forward by hand, back nut off one flat or until hole in spindle...
CLICK HERE TO GET FULL ACCESS TO 1997 Chevrolet Venture BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Chevrolet Venture cars and light trucks from 1990+.
Hydraulic Brake Systems -> Adjustments -> Height Sensing Proportioning Valve
Vehicle: 1997 Chevrolet Venture 3.4 V6 GAS
Height Sensing Proportioning Valve
The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be checked if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.
- Raise and support vehicle, leave wheels on and allow axle to hang freely.
- Remove lever retaining nut and disconnect lever from valve shaft, Fig. .
- Rotate valve shaft to permit installation of correct adjustment gauge, Fig. , ensure D shaped ho...
CLICK HERE TO GET FULL ACCESS TO 1997 Chevrolet Venture BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Chevrolet Venture cars and light trucks from 1990+.
Anti-lock Brakes -> Delphi Type VI -> Diagnosis & Testing -> 1997 -> 1997 Silhouette -> 1997 Tracker -> 1997 Trans Sport -> 1997 Venture -> 1998 -> 1998 Silhouette -> 1998 Tracker -> 1998 Trans Sport -> 1998 Venture -> 1998-99 -> 1999 Montana -> 1999 Silhouette -> 1999 Tracker -> 1999 Venture -> 1999-2001 -> 2000 Montana -> 2000 Silhouette -> 2000 Tracker -> 2000 Venture -> 2000-01 -> 20001 Venture -> 2001 Montana -> 2001 Silhouette -> 2001 Tracker -> Accessing Diagnostic Trouble Codes -> Clearing Diagnostic Trouble Codes -> Connector Pin ID -> Diagnosis Tests -> Diagnostic Trouble Code Interpretation -> Enhanced Diagnostics -> Intermittents & Poor Connections -> Montana, Silhouette, Trans Sport & Venture -> Temperature Vs. Resistance -> Tracker -> Wiring Diagrams
Vehicle: 1997 Chevrolet Venture 3.4 V6 GAS
Accessing Diagnostic Trouble Codes
Diagnostic trouble codes (DTCs) can only be read by connecting a suitably programmed scan tool to the Data Link Connector (DLC) and following the tool manufacturer instructions.
Diagnostic Trouble Code Interpretation
Refer to Figs. and , for Diagnostic Trouble Code (DTC) interpretation.
Wiring Diagrams
Refer to wiring diagrams in Vehicle Systems
Connector Pin ID
Montana, Silhouette, Trans Sport & Venture
Refer to Figs. and for connector pin identification.
Tracker
Refer to Figs. and , for connector pin identification.
Diagnosis Tests
1997 Silhouett...
[[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]]CLICK HERE TO GET FULL ACCESS TO 1997 Chevrolet Venture BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 1997 Chevrolet Venture vehicle.
|
| Access the Complete guide! |
