1997 GMC C2500 Suburban Brake Service (ONLINE REPAIR MANUALS)

Battery Ground Cable

Prior to service disconnect battery ground cable and isolate as required.

Radio Security System

Theftlock

If the Theftlock system is active when battery power is interrupted, the customers security code must be entered to restore proper function of the radio. To unlock a secured radio after power loss, proceed as follows:

• "LOC" appears with ignition in On position.
• Press "NM" and "000" will appear on display.
• Press "NM" again to make last two digits agree with security code.
• Press "HR" to make first 1 or 2 digits agree with security code.
• Press "AM-FM" to select code entered. "SEC" wi...

C & K Series

Duo-Servo

Removal

• Raise and support vehicle.
• Mark relationship of wheel to hub, then remove tire and wheel assembly.
• On models equipped with full-floating axles, remove hub and drum assembly as described in "Drive Axles."
• On models equipped with semi-floating axles, proceed as follows:
• Install pin into park brake lever.
• Mark relationship of drum to axle.
• Remove rear brake drum retainers, as required.
• Remove rear brake drum.
• On all models, remove return springs and shoe guide, Fig. .
• Remove brake hold down springs and pins.
• Disconnect actuator lever and pivot.
• Remove lever return spri...

Delco Master Cylinder

When performing the following procedures, refer to Figs. and noting that the composite reservoir may vary in design.

Disassemble

• Remove master cylinder from vehicle.
• Remove reservoir cover and diaphragm. Discard old brake fluid in reservoir.
• Inspect cover and diaphragm. Replace if cut, cracked or deformed.
• Remove fluid level switch and proportioning valve assembly, if equipped.
• Depress primary piston and remove lock ring.
• Plug primary fluid outlet (outlet nearest to cowl when master cylinder is installed), then apply compressed air into secondary fluid outlet t...

Service Brake

These brakes have self-adjusting shoe mechanisms that ensure correct lining-to-drum clearances at all times. The automatic adjusters operate only when the brakes are applied as the vehicle is moving rearward or when the car comes to an uphill stop.

Although the brakes are self-adjusting, an initial adjustment is necessary after the brake shoes have been relined or replaced, or when the length of the adjusting screw has been changed during some other service operation.

Frequent usage of an automatic transmission forward range to halt reverse vehicle motion may prevent the ...

Height Sensing Proportioning Valve

The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be checked if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.

• Raise and support vehicle, leave wheels on and allow axle to hang freely.
• Remove lever retaining nut and disconnect lever from valve shaft, Fig. .
• Rotate valve shaft to permit installation of correct adjustment gauge, Fig. , ensure D shaped ho...

General System

• Inspect components for damage or unusual wear. Replace as required.
• Inspect backing plate mounting bolts and ensure they are tight.
• Inspect wheel cylinders. Excessive fluid indicates cup leakage and need for wheel cylinder replacement. Slight amount of fluid is always present and is considered normal, acting as lubricant for cylinder pistons.
• Check adjuster screw operation. If satisfactory, lightly lubricate adjusting screw and washer with suitable brake lube. If operation is unsatisfactory, replace.
• C clean rust and dirt from shoe contact surfaces on backing plate using fi...