1998 Chevrolet C2500 Pickup Brake Service (ONLINE REPAIR MANUALS)

Battery Ground Cable

Prior to service disconnect battery ground cable and isolate as required.

Radio Security System

Theftlock

If the Theftlock system is active when battery power is interrupted, the customers security code must be entered to restore proper function of the radio. To unlock a secured radio after power loss, proceed as follows:

• "LOC" appears with ignition in On position.
• Press "NM" and "000" will appear on display.
• Press "NM" again to make last two digits agree with security code.
• Press "HR" to make first 1 or 2 digits agree with security code.
• Press "AM-FM" to select code entered. "SEC" wi...

Astro & Safari

• Apply parking brake.
• Disconnect reservoir and power steering hoses from booster.
• Remove master cylinder to brake booster retaining nuts.
• Position and support master cylinder away from booster. Do not remove hydraulic lines from master cylinder.
• Remove booster rod from top of brake pedal.
• Remove booster mounting nuts from inside of vehicle.
• Remove booster assembly and gasket.
• Reverse procedure to install, noting the following:
• Torque booster mounting nuts to 27 ft. lbs.
• Torque master cylinder retaining nuts to 27 ft. lbs.
• Torque power steering hoses to booster n...

Manual Bleed

• If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
• Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
• If master cylinder is suspected to have air in the bore, it must be bled first. To bleed master cylinder, proceed as follows:
• Disconnect forward brake pipe connection at master cylinder.
• Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
• Connect ...

This system is used on all models except Montana, Silhouette, Tracker, Trans Sport and Venture. On 2000 S & T Series , four door utility vehicles can be equipped with either a 310 or 325 ABS system. Pickups and two-door utility vehicles are equipped with 310 ABS systems. While both systems are functionally the same, the 310 differs in size and appearance from the 325. It is designed to reduce the occurrence of wheel lock-up during severe braking conditions. To accomplish this function, the system regulates hydraulic brake line pressure by using an Electro-Hydraulic Control Unit (EHC...

Excessive Pedal Travel

• Worn brake linings.
• Disc pads knock back after cornering or rough road travel.
• Piston and linings not properly seated or positioned.
• Insufficient fluid in system.
• Loose wheel bearing adjustment.
• Damaged or worn caliper piston seal.
• Improper booster pushrod adjustment.
• Pads out of flat more than .005 inch.
• Rear brake automatic adjusters inoperative.
• Improperly ground rear brake shoes.

Brake Roughness Or Chatter; Pedal Pumping

• Excessive lateral runout of rotor.
• Rotor excessively out of parallel.

Excessive Pedal Effort

• Frozen or seized pistons.
• Brake fluid, oil or grease on ...

Disassemble

• Place accumulator compressor tool No. J-26889, or equivalent, around end of accumulator.
• Install nut onto stud as shown in Fig. , then depress the accumulator with a C-clamp.
• Remove retainer by using a punch.
• Release C-clamp and remove accumulator compressor tool.
• Remove accumulator, O-ring, retainer, plug and spring, Fig. .
• Remove retainer, output pushrod, baffle, piston return spring and retainer.
• Using a suitable saw, cut off eyelet of pedal rod, then remove the boot.
• Remove nut, bracket and bolts, then separate cover from housing.
• Remove piston assembly and seal...