1998 GMC C3500 Pickup Brake Service (ONLINE REPAIR MANUALS)

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brakes will still operate, as the convention...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brakes will still operate, as the convention...

This system is used on all models except Montana, Silhouette, Tracker, Trans Sport and Venture. On 2000 S & T Series , four door utility vehicles can be equipped with either a 310 or 325 ABS system. Pickups and two-door utility vehicles are equipped with 310 ABS systems. While both systems are functionally the same, the 310 differs in size and appearance from the 325. It is designed to reduce the occurrence of wheel lock-up during severe braking conditions. To accomplish this function, the system regulates hydraulic brake line pressure by using an Electro-Hydraulic Control Unit (EHC...

In order to properly service power brake systems, a thorough understanding of the power assist system is necessary. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort necessary to obtain acceptable stopping performance.

Hydraulic assist units incorporate a basic open center spool valve, hydraulic cylinder and an accumulator assembly in a common housing. When the brake pedal is depressed, the hydraulic piston moves forward closing off fluid relief passages, the spool valve applies flui...

Removal

• Siphon ^2/3 of brake fluid from master cylinder reservoir serving front disc brakes.
• Raise and support vehicle, then remove wheel and tire assemblies.
• Bottom caliper piston in bore by inserting suitable screwdriver between inboard shoe and piston, then pry piston back into bore or by using suitable large C-clamp, Fig. .
• Remove support key retaining screw.
• Drive caliper support key and spring from steering knuckle with suitable drift and hammer, Fig. .
• Lift caliper from anchor plate and off rotor, Fig. . Hang caliper from coil spring with wire. Do not allow caliper to hang from ...

C & K Series

Duo-Servo

Removal

• Raise and support vehicle.
• Mark relationship of wheel to hub, then remove tire and wheel assembly.
• On models equipped with full-floating axles, remove hub and drum assembly as described in "Drive Axles."
• On models equipped with semi-floating axles, proceed as follows:
• Install pin into park brake lever.
• Mark relationship of drum to axle.
• Remove rear brake drum retainers, as required.
• Remove rear brake drum.
• On all models, remove return springs and shoe guide, Fig. .
• Remove brake hold down springs and pins.
• Disconnect actuator lever and pivot.
• Remove lever return spri...