Auto Parts Search

BRAKE SERVICE PROCEDURES FOR 1999 BMW M3 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 BMW M3 cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed
Vehicle: 1999 BMW M3 3.2 L6 GAS
The following procedure has been revised by a Technical Service Bulletin.
Ensure traction control systems are turned Off prior to bleeding brake system.
- Connect suitable pressure bleeder to brake fluid reservoir. Maximum charging pressure is 43.5 psi.
- Attach bleeder hose and container to righthand rear wheel. Bleed until no bubbles appear.
- Repeat previous step for lefthand rear, righthand front and lefthand front wheels.
- Support rear suspension at wheel carriers and lower car so rear suspension compresses to its normal loaded position (to prevent ...
CLICK HERE TO GET FULL ACCESS TO 1999 BMW M3 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1999 BMW M3 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 BMW M3 cars and light trucks from 1990+.
Anti-lock Brakes -> Description -> ABS Less Stability & Traction Control -> ABS w/Stability & Traction Control
Vehicle: 1999 BMW M3 3.2 L6 GAS
ABS Less Stability & Traction Control
The Anti-Lock Brake System (ABS) consists of a control unit, hydraulic unit, speed sensors and wiring harness, Fig. . Each speed sensor has a gear wheel which runs past the permanently magnetized edge of the speed sensor installed in the wheel hub. The rotary motion of the wheels is recorded by inductive sensors and an electric signal is sent to the electronic control unit.
The electronic control unit is located in a compartment on the right side of the engine compartment. This control unit inputs acceleration, deceleration and slip factors from ...
CLICK HERE TO GET FULL ACCESS TO 1999 BMW M3 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1999 BMW M3 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 BMW M3 cars and light trucks from 1990+.
Disc Brakes -> Description
Vehicle: 1999 BMW M3 3.2 L6 GAS
Refer to Figs. thro...
CLICK HERE TO GET FULL ACCESS TO 1999 BMW M3 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1999 BMW M3 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 BMW M3 cars and light trucks from 1990+.
Disc Brakes -> Caliper Service -> Assemble -> Disassemble -> Front -> Inspection -> Overhaul -> Rear -> Replace
Vehicle: 1999 BMW M3 3.2 L6 GAS
Replace
Front
- Raise and support vehicle, then remove front tire and wheel.
- Press and hold brake pedal with suitable prop.
- Disconnect brake pipe from connection with hose.
- Remove wear indicator connector from lefthand side.
- Remove mounting bolts and caliper.
- Reverse procedure to install, noting the following:
- Tighten mounting bolts to specifications.
- Bleed brake system.
- Ensure brake pad wear sensor wire does not contact rotor or wheel.
Rear
- Raise and support vehicle, then remove rear tire and wheel assembly.
- Drain moderate amount of brake fluid from reservoir using suitable syringe.
- Disconnect...
CLICK HERE TO GET FULL ACCESS TO 1999 BMW M3 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1999 BMW M3 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 BMW M3 cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> 323Ci, 325, 328Ci & 330 & 2000 323i & 328i & 1999 323i & 328i Sedans -> 740 & 750 -> M3, Z3, 318, 3232, 325, 328 & 330 -> M5, 525, 528, 530 & 540 -> Master Cylinder, Replace -> X5 -> Z3, 318, 323is & 328is & 1998-99 M3, 328i & 1998 323i & 1999 323i & 328i Convertibles
Vehicle: 1999 BMW M3 3.2 L6 GAS
Master Cylinder, Replace
M3, Z3, 318, 3232, 325, 328 & 330
Z3, 318, 323is & 328is & 1998-99 M3, 328i & 1998 323i & 1999 323i & 328i Convertibles
- Remove brake fluid from master cylinder using suitable syringe.
- Remove mounting bolt.
- Disconnect reservoir from master cylinder by titling to side.
- Plug master cylinder connections.
- Disconnect brake lines, then plug bores and lines.
- Remove mounting nuts and master cylinder.
- Remove plug and clutch hose, as required.
- Reverse procedure to install, noting the following:
- Install new mounting nuts and seal.
- Coat sealing rings with suitable brake fl...
CLICK HERE TO GET FULL ACCESS TO 1999 BMW M3 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1999 BMW M3 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 BMW M3 cars and light trucks from 1990+.
Disc Brakes -> Parking Brake Specifications
Vehicle: 1999 BMW M3 3.2 L6 GAS
CLICK HERE TO GET FULL ACCESS TO 1999 BMW M3 BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |