1999 Ford Crown Victoria Brake Service (ONLINE REPAIR MANUALS)

Remove wheels and inspect brake disc, calipers and linings. Inspect and repack wheel bearings if required.

If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.

If caliper was removed when installing new components, clean all components in alcohol, then wipe dry using lint-free cloths. Using an air hose, blow out drilled passages and bores. Inspect dust boots for punctures or tears. If punctures or tears are evident, install new boots during assembly.

Inspect piston bores in both housings for scoring or pitting. Bores showing light scr...

Whenever new brake components are installed in the hydraulic system, it is recommended that the entire hydraulic system be thoroughly flushed with clean brake fluid.

It may sometime become required to flush out the system due to the presence of mineral oil, kerosene, gasoline, etc., which will cause swelling of rubber piston cups and valves and render them inoperative.

Flushing is performed at e...

The anti-lock brake system prevents wheel lock-up by automatically modulating brake pressure during an emergency stop. It allows driver to maintain steering control and stop the vehicle in the shortest possible distance under most conditions. The traction control system controls wheelspin by modulating engine torque and applying or releasing appropriate rear brake to restore traction when driving on slippery or loose surfaces, Fig. .

System Components

Vacuum Booster

The diaphragm type brake booster is self-contained and is mounted on the left side of engine compartment. The vacuum brak...

Continental, Cougar, LS, Mustang, Sable & Taurus

Sliding caliper rear disc brakes are used on these models. The caliper is basically the same as the larger front wheel caliper. However, a parking brake mechanism and a larger inner brake shoe anti-rattle spring have been added.

The parking brake lever, located at the rear of the caliper, is actuated by a cable system similar to rear drum brake applications. When the parking brake is applied, the cable rotates the lever and operating shaft, driving the caliper piston and brake shoe assembly against the rotor. An automatic adjuster in th...

Pressure bleeding is recommended for all hydraulic brake systems. Ensure all dirt and contaminants are removed from master cylinder area prior to removing reservoir cap.

To prevent air from the pressure tank getting into the lines, do not shake the tank while air is being added to the tank or after it has been pressurized. Set the tank in the required location, bring the air hose to the tank, and do not move it during the bleeding operation. The tank should be kept at least one-third full.

On vehicles equipped with disc brakes and master cylinders without proportioners or press...

Remove wheels and inspect brake disc, caliper and linings. Inspect wheel bearings and repack if required.

If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.

If caliper is removed when installing new components, clean all components in alcohol, then wipe dry using lint-free cloths. Blow out drilled passages and bores with compressed air. Inspect dust boots for punctures or tears, replace as required.

Inspect piston bores in both housings for scoring or pitting. Bores showing light scratches or corrosion can be cleaned with crocus clo...