1999 Volkswagen Eurovan Brake Service (ONLINE REPAIR MANUALS)

Auto Parts Search


Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!
Help me findSearch
Get Full Access Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 1999 Volkswagen Eurovan car and truck repair procedures including Volkswagen engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up & drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix your 1999 Volkswagen Eurovan automobile. Try the Automotix DIY solution today!
DIY REPAIR SAMPLES > CONTINUE EXPLORING >

BRAKE SERVICE PROCEDURES FOR 1999 Volkswagen Eurovan AUTOMOBILES

Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 Volkswagen Eurovan cars and light trucks from 1990+.

Disc Brakes -> Teves/Ate Single Piston w/Dual Mounting Bolts, Front -> Brake Pad Service
Vehicle: 1999 Volkswagen Eurovan 2.8 V6 GAS

Brake pads used in this caliper are directional, if pads are to be reinstalled mark them for location prior to removal.

Always remove some brake fluid from master cylinder reservoir prior to installing new pads. When caliper piston is pushed back, fluid is forced out of caliper and into reservoir. After pads are installed and seated, fill reservoir to MAX mark.

  • Raise and support vehicle, then remove front wheels.
  • Pry off brake pad retaining spring using a suitable pry bar, Fig. .
  • Remove protective caps from caliper guide pin bushings.
  • Remove upper and lower guide pins from caliper...

CLICK HERE TO GET FULL ACCESS TO 1999 Volkswagen Eurovan BRAKE SERVICE PROCEDURES

BRAKE SERVICE PROCEDURES FOR 1999 Volkswagen Eurovan AUTOMOBILES

Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 Volkswagen Eurovan cars and light trucks from 1990+.

Disc Brakes -> Single Piston Rear Disc Brake -> Brake Caliper Pre-Bleeding
Vehicle: 1999 Volkswagen Eurovan 2.8 V6 GAS

  • Place caliper so that piston bore is facing downward.
  • Open bleeder valve, then connect ...

CLICK HERE TO GET FULL ACCESS TO 1999 Volkswagen Eurovan BRAKE SERVICE PROCEDURES

BRAKE SERVICE PROCEDURES FOR 1999 Volkswagen Eurovan AUTOMOBILES

Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 Volkswagen Eurovan cars and light trucks from 1990+.

Disc Brakes -> Single Piston Rear Disc Brake -> Tightening Specifications
Vehicle: 1999 Volkswagen Eurovan 2.8 V6 GAS

[[table data]]

CLICK HERE TO GET FULL ACCESS TO 1999 Volkswagen Eurovan BRAKE SERVICE PROCEDURES

BRAKE SERVICE PROCEDURES FOR 1999 Volkswagen Eurovan AUTOMOBILES

Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 Volkswagen Eurovan cars and light trucks from 1990+.

Hydraulic Brake Systems -> Brake System Bleed -> Conventional Bleed -> Pressure Bleed -> Scan Tool Bleed
Vehicle: 1999 Volkswagen Eurovan 2.8 V6 GAS

Conventional Bleed
  • Connect suitable bottle with transparent hose to each wheel.
  • Pump brake pedal several times, then hold.
  • Open and close bleeder screw, then release pedal.
  • Bleed brake system using the following sequence:
    • Righthand rear caliper/wheel cylinder.
    • Lefthand rear caliper/wheel cylinder.
    • Righthand front caliper.
    • Lefthand front caliper.
  • Repeat procedure until brake fluid flows without air bubbles.
Pressure Bleed
  • Connect brake filling and bleeding unit tool No. US 1116, or equivalent.
  • On models equipped with brake pressure regu...

CLICK HERE TO GET FULL ACCESS TO 1999 Volkswagen Eurovan BRAKE SERVICE PROCEDURES

BRAKE SERVICE PROCEDURES FOR 1999 Volkswagen Eurovan AUTOMOBILES

Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 Volkswagen Eurovan cars and light trucks from 1990+.

Anti-lock Brakes -> Precautions -> Audio Coded Anti-Theft System -> Battery Ground Cable -> Brake Fluid
Vehicle: 1999 Volkswagen Eurovan 2.8 V6 GAS

Battery Ground Cable

Prior to service, disconnect battery ground cable and isolate as required.

Audio Coded Anti-Theft System

Some models are equipped with a radio anti-theft system that will disable the system when battery power is interrupted. Unless the system is reset the radio will not operate.

  • Turn radio On. SAFE and 1000 should be displayed.
  • Enter radio code using first four program station buttons. Security code will appear on display.
  • Depress and hold righthand side of rad...

CLICK HERE TO GET FULL ACCESS TO 1999 Volkswagen Eurovan BRAKE SERVICE PROCEDURES

BRAKE SERVICE PROCEDURES FOR 1999 Volkswagen Eurovan AUTOMOBILES

Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1999 Volkswagen Eurovan cars and light trucks from 1990+.

Anti-lock Brakes -> System Service -> Bosch 5 -> Bosch 5.3 -> Brake System Bleed -> Cabrio, Golf, GTI, Jetta & New Beetle -> Coding Control Module -> Component Replacement -> Control Module -> EuroVan -> Hydraulic Modulator -> ITT Mark 20 IE -> Passat -> Teves Type 04 -> Teves Type 20
Vehicle: 1999 Volkswagen Eurovan 2.8 V6 GAS

Brake System Bleed

Refer to "Hydraulic Brake Systems" for bleeding procedure.

Component Replacement

Bosch 5.3, ITT Mark 20 and Teves model 20 ABS control modules are coded to the vehicle. Replacement control modules must be coded after installation. Refer to "Coding Control Module" for procedures.

Prior to servicing the ABS system, always turn the ignition off.

The ABS control unit must never be exposed to temperatures greater than 185°F for more than two hours, or 203°F for even short time periods. The ABS control unit must be unplugged if an electric welder is to be used on the vehicle.

...

CLICK HERE TO GET FULL ACCESS TO 1999 Volkswagen Eurovan BRAKE SERVICE PROCEDURES

Shop online for auto body parts, engines, wheels, lights...

More parts
Help me findSearch
Auto Repair Quick Search
Help me find
Search DIY repair manuals by VIN...
Vehicle Identification Number is a unique serial number used by the automotive industry to identify individual motor vehicles

Find out what info we have for your vehicle

Get the Complete Technical Service Bulletins!
Get the Complete Technical Service Bulletins!Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1999 Volkswagen Eurovan vehicle.
Access the Complete guide!
Need To Fix Your Car or Truck?
Save Money With Free Car Insurance Quote
FREE car insurance quote
Enter Zip Code:
Auto Repair Quick Search
Help me find