2000 Chevrolet Tahoe Brake Service (ONLINE REPAIR MANUALS)

Manual Bleed

• If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
• Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
• If master cylinder is suspected to have air in the bore, it must be bled first. To bleed master cylinder, proceed as follows:
• Disconnect forward brake pipe connection at master cylinder.
• Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
• Connect ...

Removal

• Siphon ^2/3 of the brake fluid from master cylinder.
• Raise and support vehicle.
• Remove tire and wheel assembly.
• Compress caliper pistons until they bottom in bores using suitable clamp, Fig. .
• Disconnect brake hose at caliper by removing inlet fitting bolt.
• Remove mounting bolts and caliper.

Inspection

Should it become necessary to remove the caliper for installation of new parts, clean parts in denatured alcohol, wipe dry using lint-free cloths. Blow out drilled passages and holes using compressed air. Check dust boots for punctures or tears. If punctures or tears are evident, n...

In order to properly service power brake systems, a thorough understanding of the various power assist systems is necessary. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort necessary to obtain acceptable stopping performance. Two basic types of power assist mechanisms are used: vacuum assist diaphragm assemblies which use engine vacuum and in some cases vacuum from an external vacuum pump, and hydraulic assist assemblies which use hydraulic pressure developed by an external pump (...

Master Cylinder

Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.

Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.

The quick take-up uses a spring-loaded ball check val...

The power brake unit is n...

This system is used on all models except Montana, Silhouette, Tracker, Trans Sport and Venture. On 2000 S & T Series , four door utility vehicles can be equipped with either a 310 or 325 ABS system. Pickups and two-door utility vehicles are equipped with 310 ABS systems. While both systems are functionally the same, the 310 differs in size and appearance from the 325. It is designed to reduce the occurrence of wheel lock-up during severe braking conditions. To accomplish this function, the system regulates hydraulic brake line pressure by using an Electro-Hydraulic Control Unit (EHC...