Auto Parts Search

We have info for following modifications of 2000 GMC K3500 Pickup
- 2000 GMC K3500 Pickup 5.7 V8 GAS, CID:350, Fuel Injection, Aspiration:350, Engine VIN:, Desg:R
- 2000 GMC K3500 Pickup 6.5 V8 DIESEL, CID:395, Fuel Injection, Aspiration:395, Engine VIN:, Desg:F
- 2000 GMC K3500 Pickup 7.4 V8 GAS, CID:454, Fuel Injection, Aspiration:454, Engine VIN:, Desg:J
BRAKE SERVICE PROCEDURES FOR 2000 GMC K3500 Pickup AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 GMC K3500 Pickup cars and light trucks from 1990+.
Drum Brakes -> Brake Service -> Astro, Bravada, S & T Series & Safari -> Aztek -> C & K Series -> Duo-Servo -> G Series -> Installation -> Montana, Silhouette, Trans Sport & Venture -> P Series -> Removal -> Single-Servo -> Tracker
Vehicle: 2000 GMC K3500 Pickup 7.4 V8 GAS
C & K Series
Duo-Servo
Removal
- Raise and support vehicle.
- Mark relationship of wheel to hub, then remove tire and wheel assembly.
- On models equipped with full-floating axles, remove hub and drum assembly as described in "Drive Axles."
- On models equipped with semi-floating axles, proceed as follows:
- Install pin into park brake lever.
- Mark relationship of drum to axle.
- Remove rear brake drum retainers, as required.
- Remove rear brake drum.
- On all models, remove return springs and shoe guide, Fig. .
- Remove brake hold down springs and pins.
- Disconnect actuator lever and pivot.
- Remove lever return spri...
CLICK HERE TO GET FULL ACCESS TO 2000 GMC K3500 Pickup BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 GMC K3500 Pickup AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 GMC K3500 Pickup cars and light trucks from 1990+.
Hydraulic Brake Systems -> Adjustments -> Height Sensing Proportioning Valve
Vehicle: 2000 GMC K3500 Pickup 5.7 V8 GAS
Height Sensing Proportioning Valve
The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be checked if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.
- Raise and support vehicle, leave wheels on and allow axle to hang freely.
- Remove lever retaining nut and disconnect lever from valve shaft, Fig. .
- Rotate valve shaft to permit installation of correct adjustment gauge, Fig. , ensure D shaped ho...
CLICK HERE TO GET FULL ACCESS TO 2000 GMC K3500 Pickup BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 GMC K3500 Pickup AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 GMC K3500 Pickup cars and light trucks from 1990+.
Power Brake Units -> Bendix Brake Booster -> Power Brake Unit Replacement -> Astro & Safari -> C & K Series -> G Series -> P Series
Vehicle: 2000 GMC K3500 Pickup 5.7 V8 GAS
Astro & Safari
- Apply parking brake.
- Disconnect reservoir and power steering hoses from booster.
- Remove master cylinder to brake booster retaining nuts.
- Position and support master cylinder away from booster. Do not remove hydraulic lines from master cylinder.
- Remove booster rod from top of brake pedal.
- Remove booster mounting nuts from inside of vehicle.
- Remove booster assembly and gasket.
- Reverse procedure to install, noting the following:
- Torque booster mounting nuts to 27 ft. lbs.
- Torque master cylinder retaining nuts to 27 ft. lbs.
- Torque power steering hoses to booster n...
CLICK HERE TO GET FULL ACCESS TO 2000 GMC K3500 Pickup BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 GMC K3500 Pickup AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 GMC K3500 Pickup cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed -> Hydraulic System Flush -> Manual Bleed -> Master Cylinder Bleed -> Parking Brake Bleed -> Pressure Bleed
Vehicle: 2000 GMC K3500 Pickup 7.4 V8 GAS
Manual Bleed
- If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
- Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
- If master cylinder is suspected to have air in the bore, it must be bled first. To bleed master cylinder, proceed as follows:
- Disconnect forward brake pipe connection at master cylinder.
- Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
- Connect ...
CLICK HERE TO GET FULL ACCESS TO 2000 GMC K3500 Pickup BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 GMC K3500 Pickup AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 GMC K3500 Pickup cars and light trucks from 1990+.
Anti-lock Brakes -> Kelsey-Hayes -> Description
Vehicle: 2000 GMC K3500 Pickup 7.4 V8 GAS
This system is used on all models except Montana, Silhouette, Tracker, Trans Sport and Venture. On 2000 S & T Series , four door utility vehicles can be equipped with either a 310 or 325 ABS system. Pickups and two-door utility vehicles are equipped with 310 ABS systems. While both systems are functionally the same, the 310 differs in size and appearance from the 325. It is designed to reduce the occurrence of wheel lock-up during severe braking conditions. To accomplish this function, the system regulates hydraulic brake line pressure by using an Electro-Hydraulic Control Unit (EHC...
CLICK HERE TO GET FULL ACCESS TO 2000 GMC K3500 Pickup BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 GMC K3500 Pickup AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 GMC K3500 Pickup cars and light trucks from 1990+.
Anti-lock Brakes -> Kelsey-Hayes -> Diagnosis & Testing -> 1997 Astro -> 1997 C & K Series -> 1997 G-Series -> 1997 P-Series -> 1997 S & T Series -> 1997-99 -> 1997-99 Except 1999 Sierra & Silverado -> 1997-99 G Van & P Series -> 1998 Astro -> 1998 C & K Series -> 1998 G-Series -> 1998 P-Series -> 1998 S & T Series -> 1999 Astro -> 1999 C & K Series Except Sierra & Silverado -> 1999 G-Series -> 1999 P-Series -> 1999 S & T Series -> 1999 Sierra & Silverado -> 2000 Astro -> 2000 C & K Series except Sierra, Silverado, Suburban, Tahoe & Yukon -> 2000 G-Series -> 2000 S & T Series -> 2000 Sierra -> 2000 Silverado -> 2000 Suburban -> 2000 Tahoe -> 2000 Yukon -> 2000-01 -> 2000-01 G Van -> 2001 Astro -> 2001 C & K Series -> 2001 G-Series -> 2001 S & T Series -> Accessing Diagnostic Trouble Codes -> Astro, Safari & S & T Series -> C & K Series -> Clearing Diagnostic Trouble Codes -> Connector Pin ID -> Diagnostic Process -> Diagnostic Tests -> Diagnostic Trouble Code Interpretation -> Enhanced Diagnostics -> G Van & P Series -> Intermittents & Poor Connections -> Temperature Vs. Resistance -> Wiring Diagrams
Vehicle: 2000 GMC K3500 Pickup 6.5 V8 DIESEL
Accessing Diagnostic Trouble Codes
Diagnostic trouble codes (DTCs) can only be read by connecting a suitably programmed scan tool to the Data Link Connector (DLC) and following the tool manufacturer instructions.
Diagnostic Trouble Code Interpretation
Refer to Figs. and , for Diagnostic Trouble Code (DTC) interpretation.
Wiring Diagrams
Refer "Wiring Diagrams" in "Vehicle Systems"
Connector Pin ID
On 2000 S & T Series only, ensure correct anti-lock brake system connector pin identifications are used.
[[table data]]Diagnostic Process
- Inspect master cylinder reservoir fluid level and for possible fluid...
CLICK HERE TO GET FULL ACCESS TO 2000 GMC K3500 Pickup BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |