Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2000 Honda Civic car and truck
repair procedures including Honda engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2000 Honda Civic automobile. Try the Automotix DIY solution today!
We have info for following modifications of 2000 Honda Civic
- 2000 Honda Civic CX 1.6 L4 GAS, CC:1590, Fuel Injection
- 2000 Honda Civic DX 1.6 L4 GAS, CC:1590, Fuel Injection
- 2000 Honda Civic EX 1.6 L4 GAS, CC:1590, Fuel Injection
- 2000 Honda Civic HX 1.6 L4 GAS, CC:1590, Fuel Injection
- 2000 Honda Civic LX 1.6 L4 GAS, CC:1590, Fuel Injection
- 2000 Honda Civic SI 1.6 L4 GAS, CC:1595, Fuel Injection
- 2000 Honda Civic GX 1.6 L4 CNG, CC:1590, Fuel Injection
BRAKE SERVICE PROCEDURES FOR 2000 Honda Civic AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Civic cars and light trucks from 1990+.
Anti-lock Brakes -> System Service -> 1997-2000 -> 1997-2001 -> 2002 -> Accord -> Accord & Odyssey -> Accumulator -> Accumulator Disposal -> Brake Fluid Change -> Brake System Bleed -> Civic -> Civic & CR-V -> Component Replacement -> Control Unit -> CR-V -> del Sol -> del Sol & Prelude -> Front -> Front Speed Sensor -> Modulator -> Odyssey -> Prelude -> Pulser & Sensor Gap Measurement -> Rear -> Rear Speed Sensor -> S2000 -> System Pressure Relief
Vehicle: 2000 Honda Civic LX 1.6 L4 GAS
System Pressure Relief
Accord & Odyssey
- Remove bleeder cap from maintenance bleeder on modulator unit, then attach a suitable wrench to bleeder.
- Connect a rubber tube to bleeder and place other end in a container, Fig. .
- While holding tube in hand, loosen maintenance bleeder 1/8- 1/4 turn and collect fluid in container. Do not loosen bleeder too much; brake fluid is under high pressure and can burst out.
- Tighten maintenance bleeder to specification.
del Sol
- Drain brake fluid from master cylinder and modulator reservoir thoroughly as outlined under "Brake Fluid Change."
- Using bleeder t-wre...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Civic BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Honda Civic AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Civic cars and light trucks from 1990+.
Disc Brakes -> Parking Brake Service -> Adjustment
Vehicle: 2000 Honda Civic LX 1.6 L4 GAS
Adjustment
Refer to...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Civic BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Honda Civic AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Civic cars and light trucks from 1990+.
Drum Brakes -> Adjustments -> 1997-2001 -> 1997-98 -> 1999-2001 -> 2002 -> Accord -> Civic -> CR-V -> Del Sol -> Major Adjustment -> Minor Adjustment -> Odyssey -> Parking Brake -> Prelude -> S2000
Vehicle: 2000 Honda Civic DX 1.6 L4 GAS
Parking Brake
Accord
- Raise and support vehicle.
- On models equipped with rear disc brakes, ensure parking brake arm on rear caliper is in contact with brake caliper pin.
- On all models, pull parking brake lever up one click, then remove rear center console lid.
- Tighten adjusting nut until brakes drag slightly when turning rear wheels.
- Fully release parking brake, ensure brakes do not drag when turning rear wheels.
- Fully apply parking brake, ensure wheels do not turn.
- Install console lid.
Civic
- Raise and support vehicle.
- On models equipped with rear disc brakes, ensure parking brake arm on rear c...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Civic BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Honda Civic AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Civic cars and light trucks from 1990+.
Power Brake Units -> Power Brake Unit Service -> Accord, Odyssey & Prelude -> Civic, CR-V, del Sol & S2000 -> Power Booster Overhaul -> Power Booster, Replace
Vehicle: 2000 Honda Civic CX 1.6 L4 GAS
Power Booster, Replace
Accord, Odyssey & Prelude
- Remove master cylinder as outlined under "Hydraulic Brake Systems."
- Disconnect vacuum hose from booster, then remove vacuum hose bracket.
- Remove throttle control cable bracket, then disconnect engine wire harness connectors.
- On models equipped with manual transmission, remove clutch reservoir and reservoir bracket. Do not disconnect clutch hose from reservoir.
- On all models, loosen pushrod locknut, then remove cotter pin and joint pin.
- Remove clevis from operating rod of brake booster, then four booster mounting nuts.
- Pull brake bo...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Civic BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Honda Civic AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Civic cars and light trucks from 1990+.
Disc Brakes -> Caliper Service -> Assemble -> Disassemble -> Front -> Overhaul -> Rear -> Replace
Vehicle: 2000 Honda Civic DX 1.6 L4 GAS
Front
Replace
Ensure dirt or other foreign matter is not allowed to contaminate brake fluid. Do not mix different types of brake fluid, as they might not be compatible.
- Refer to Figs. through when replacing calipers.
- Raise and support front of vehicle, then remove wheel and tire assemblies.
- Remove banjo bolt and disconnect brake hose from caliper.
- Remove caliper bolts, then the caliper.
- Reverse procedure to install.
Overhaul
Disassemble
- Refer toFigs. through when overhauling calipers.
- Remove caliper assembly from vehicle as outlined under " Brake Pad Service."
- Remove pad spring from calip...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Civic BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Honda Civic AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Civic cars and light trucks from 1990+.
Disc Brakes -> Brake Pad Service -> Front -> Installation -> Rear -> Removal
Vehicle: 2000 Honda Civic SI 1.6 L4 GAS
Front
Removal
- Refer to Figs. through when replacing brake pads.
- Raise and support front of vehicle, then remove wheel and tire assemblies.
- Remove brake hose clamp bolts from steering knuckle, Fig. .
- Remove caliper bolt, then swing caliper up out of the way.
- Remove shims, retainers and brake pads.
Installation
- Using vernier caliper, measure thickness of each pad lining. Compare measurement with specifications. If brake lining thickness is less than specified, replace both pads as a set.
- Clean caliper thoroughly, and check for grooves or cracks. Repair or replace as necessary.
- Install ...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Civic BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
