Auto Parts Search
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Accent AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Accent cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Service -> Master Cylinder Overhaul
Vehicle: 2000 Hyundai Accent 1.5 L4 GAS
Master Cylinder Overhaul
- Remove reservoir cap, drain brake fluid into a suitable container, then remove reservoir from master cylinder, Figs. through .
- Remove snap ring while depressing piston with a blunt tool. If necessary, secure master cylinder in a suitable soft jawed vise.
- On all models except Santa Fe, Sonata, XG 300 & XG 350 models, remove primary and secondary pistons from master cylinder body. Do not disassemble primary and secondary pistons.
- On Santa Fe,...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Accent BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Accent AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Accent cars and light trucks from 1990+.
Power Brake Units -> Troubleshooting -> Check Valve Operation
Vehicle: 2000 Hyundai Accent 1.5 L4 GAS
Check Valve Operation
- Remove booster hose from check valve.
- Start engi...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Accent BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Accent AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Accent cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> Master Cylinder
Vehicle: 2000 Hyundai Accent 1.5 L4 GAS
Master Cylinder
- Disconnect electrical connector from fluid level switch, if equipped, Figs. through .
- Disconnect brake lines from master cylinder and plug open ports.
- Remove master cylinder mounting nuts, then remove ma...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Accent BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Accent AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Accent cars and light trucks from 1990+.
Disc Brakes -> Caliper Service -> Accent -> Assemble -> Disassemble -> Elantra & Tiburon -> Elantra, Sonata & Tiburon -> Front -> Installation -> Rear -> Removal -> Santa Fe -> Sonata -> XG 300 & XG 350
Vehicle: 2000 Hyundai Accent 1.5 L4 GAS
Front
Accent
Removal
- Remove wheel/tire assembly.
- Remove brake hose from caliper and cap brake line(s).
- Remove caliper assembly as outlined under, "Brake Pad Service."
Disassemble
- Remove sleeve, sleeve boot and pin boots, Fig. .
- Protect fingers with shop towel, then blow piston from caliper bore with compressed air.
- Remove piston boot, then pry piston seal from caliper bore using a suitable screwdriver.
Assemble
- Clean all components with suitable cleaner.
- Inspect caliper bore, piston and carrier for damage or excessive wear.
- Apply suitable rubber grease to new piston seal, then install piston s...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Accent BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Accent AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Accent cars and light trucks from 1990+.
Anti-lock Brakes -> Troubleshooting -> Preliminary Inspection -> System Diagnosis Step Indicator Check
Vehicle: 2000 Hyundai Accent 1.5 L4 GAS
Preliminary Inspection
Start engine and drive at a speed of 3-6 mph, then verify that the modulator is operating by listening for motor pump hum and solenoid clicking for one or two seconds. Procedure should be performed within first three minutes after start up. Solenoid valve and motor pum...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Accent BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Accent AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Accent cars and light trucks from 1990+.
Disc Brakes -> Brake Pad Service -> 1997-98 -> 1999-2002 -> Accent -> Elantra & Tiburon -> Elantra, Sonata & Tiburon -> Front -> Rear -> Santa Fe -> Sonata -> XG 300 & XG 350
Vehicle: 2000 Hyundai Accent 1.5 L4 GAS
Front
Accent
- Raise and support vehicle, then remove wheel/tire assembly.
- Remove lower bolt and caliper assembly, Fig. . Position assembly aside using suitable wire.
- Remove brake pads and shim.
- Bottom piston in caliper using a suitable tool.
- Install new brake pads and attach shim to the outer pad. Tighten lower bolt to specifications.
Elantra, Sonata & Tiburon
- Raise and support vehicle, then remove wheel/tire assembly.
- Remove two mounting bolts attaching caliper to torque plate, Fig. .
- Remove brake caliper assembly, then position aside using suitable wire.
- Remove brake pads.
- Install pad c...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Accent BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2000 Hyundai Accent vehicle. |
Access the Complete guide! |