Auto Parts Search
BRAKE SERVICE PROCEDURES FOR 2001 BMW Z8 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 BMW Z8 cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed
Vehicle: 2001 BMW Z8 5.0 V8 GAS
The following procedure has been revised by a Technical Service Bulletin.
Ensure traction control systems are turned Off prior to bleeding brake system.
- Connect suitable pressure bleeder to brake fluid reservoir. Maximum charging pressure is 43.5 psi.
- Attach bleeder hose and container to righthand rear wheel. Bleed until no bubbles appear.
- Repeat previous step for lefthand rear, righthand front and lefthand front wheels.
- Support rear suspension at wheel carriers and lower vehicle so rear suspension compresses to its normal loaded position (to prevent...
CLICK HERE TO GET FULL ACCESS TO 2001 BMW Z8 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 BMW Z8 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 BMW Z8 cars and light trucks from 1990+.
Disc Brakes -> Brake Pad Service -> Front -> Pads, Replace -> Rear
Vehicle: 2001 BMW Z8 5.0 V8 GAS
Pads, Replace
Front
- Raise and support vehicle, then remove front tire and wheel assemblies.
- Remove retaining spring.
- Disconnect brake pad wear indicator connector from lefthand side of caliper.
- Remove plastic plugs and remove brake hose out from bracket.
- Remove guide bolts and lift brake caliper toward vehicle rear.
- Remove brake pads and suspend caliper aside with suitable wire.
- Reverse procedure to install, noting the following:
- Turn caliper piston back into bore using fixture tool No. 34 1 050, or equivalent.
- Inspect fluid level and bleed brake system as required.
- Replace dust sleeve a...
CLICK HERE TO GET FULL ACCESS TO 2001 BMW Z8 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 BMW Z8 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 BMW Z8 cars and light trucks from 1990+.
Disc Brakes -> Tightening Specifications
Vehicle: 2001 BMW Z8 5.0 V8 GAS
CLICK HERE TO GET FULL ACCESS TO 2001 BMW Z8 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 BMW Z8 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 BMW Z8 cars and light trucks from 1990+.
Power Brake Units -> Power Brake Unit Service -> 740 & 750 -> 745 -> Hydraulic Power Flow Regulator, Replace -> M3, 325 & 330 -> M3, M5, X5, Z3, Z8, 325, 330, 525, 530, 540, 740, 745, 750 & 760 -> M5, 525, 530 & 540 -> Mini Cooper -> Power Brake Booster, Replace -> X5 -> Z3 -> Z8
Vehicle: 2001 BMW Z8 5.0 V8 GAS
Hydraulic Power Flow Regulator, Replace
Mini Cooper
- Ensure ignition switch is in OFF position.
- Disconnect clip and air filter outlet hose.
- Remove air filter housing mounting bolts, then disconnect harness clip and connector.
- Remove air filter housing.
- With engine off, discharge hydraulic reservoir by operating brake pedal approximately 20 times with same force required for full stop braking action.
- Remove battery.
- Disconnect clips, lock and connectors, then remove Engine Control Module (ECM).
- Remove battery box mounting bolt and disconnect clips.
- Remove battery box.
- Disconnect val...
CLICK HERE TO GET FULL ACCESS TO 2001 BMW Z8 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 BMW Z8 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 BMW Z8 cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> 740 & 750 -> 745 -> M3, 325 & 330 -> M5, 525, 530 & 540 -> Master Cylinder, Replace -> Mini Cooper -> X5 -> Z3 -> Z8
Vehicle: 2001 BMW Z8 5.0 V8 GAS
Master Cylinder, Replace
Mini Cooper
- Suck brake fluid from expansion tank into suitable container using suitable suction bottle.
- Disconnect brake fluid level switch connector.
- Disconnect clutch hydraulic supply hose. Position line so that fluid does not drain. Plug or cap lines and openings.
- Disconnect expansion tank booster vacuum hose.
- Remove mounting bolt and expansion tank.
- Remove battery.
- Disconnect clips, lock and connectors, then remove Engine Control Module (ECM).
- Remove battery box mounting bolt and disconnect clips.
- Remove battery box.
- Disconnect brake lines. Plug or cap li...
CLICK HERE TO GET FULL ACCESS TO 2001 BMW Z8 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 BMW Z8 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 BMW Z8 cars and light trucks from 1990+.
Power Brake Units -> Diagnosis & Testing -> Brake Booster Low-Pressure Test
Vehicle: 2001 BMW Z8 5.0 V8 GAS
Brake Booster Low-Pressure Test
- Disconnect brake booster vacuum hose.
- Install vacuum test tool No. 34 3 100, or equivalent, between booster and check valve.
- Start engine and build up partial vacuum.
- Switch engine off.
- Press brake pedal to set partial vacuum of no more than 12 psi.
- When brake pedal is not pressed, partial vacuum...
CLICK HERE TO GET FULL ACCESS TO 2001 BMW Z8 BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2001 BMW Z8 vehicle. |
Access the Complete guide! |