2001 Chevrolet Silverado 2500 HD Brake Service (ONLINE REPAIR MANUALS)

In order to properly service power brake systems, a thorough understanding of the power assist system is necessary. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort necessary to obtain acceptable stopping performance.

Hydraulic assist units incorporate a basic open center spool valve, hydraulic cylinder and an accumulator assembly in a common housing. When the brake pedal is depressed, the hydraulic piston moves forward closing off fluid relief passages, the spool valve applies flui...

Master Cylinder

Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.

Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.

The quick take-up uses a spring-loaded ball check val...

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level because of a chemical breakdown during use and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent ...

Removal

• Siphon ^2/3 of the brake fluid from master cylinder.
• Raise and support vehicle.
• Remove tire and wheel assembly.
• Compress caliper pistons until they bottom in bores using suitable clamp, Fig. .
• Disconnect brake hose at caliper by removing inlet fitting bolt.
• Remove mounting bolts and caliper.

Inspection

Should it become necessary to remove the caliper for installation of new parts, clean parts in denatured alcohol, wipe dry using lint-free cloths. Blow out drilled passages and holes using compressed air. Check dust boots for punctures or tears. If punctures or tears are evident, n...

The caliper mounts in a way that allows the caliper to move laterally inboard as the brake pads wear. The caliper housing is a one piece casting with the inboard side containing the piston bore. The piston seal also acts as a return mechanism for the piston.

Applying the brake pedal causes the hydraulic pressure that moves the caliper piston. The piston then forces the inboard brake pad against the inboard braking surface of the rotor. Increasing the force against...