2001 Chevrolet Silverado 3500 Brake Service (ONLINE REPAIR MANUALS)

Manual Bleed

• If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
• Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
• If master cylinder is suspected to have air in the bore, it must be bled first. To bleed master cylinder, proceed as follows:
• Disconnect forward brake pipe connection at master cylinder.
• Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
• Connect ...

Astro & Safari

• Apply parking brake.
• Disconnect reservoir and power steering hoses from booster.
• Remove master cylinder to brake booster retaining nuts.
• Position and support master cylinder away from booster. Do not remove hydraulic lines from master cylinder.
• Remove booster rod from top of brake pedal.
• Remove booster mounting nuts from inside of vehicle.
• Remove booster assembly and gasket.
• Reverse procedure to install, noting the following:
• Torque booster mounting nuts to 27 ft. lbs.
• Torque master cylinder retaining nuts to 27 ft. lbs.
• Torque power steering hoses to booster n...

Battery Ground Cable

Prior to service disconnect battery ground cable and isolate as required.

Radio Security System

Theftlock

If the Theftlock system is active when battery power is interrupted, the customers security code must be entered to restore proper function of the radio. To unlock a secured radio after power loss, proceed as follows:

• "LOC" appears with ignition in On position.
• Press "NM" and "000" will appear on display.
• Press "NM" again to make last two digits agree with security code.
• Press "HR" to make first 1 or 2 digits agree with security code.
• Press "AM-FM" to select code entered. "SEC" wi...

Astro & Safari

• Apply parking brake.
• Disconnect reservoir and power steering hoses from booster.
• Remove master cylinder to brake booster retaining nuts.
• Position and support master cylinder away from booster. Do not remove hydraulic lines from master cylinder.
• Remove booster rod from top of brake pedal.
• Remove booster mounting nuts from inside of vehicle.
• Remove booster assembly and gasket.
• Reverse procedure to install, noting the following:
• Torque booster mounting nuts to 27 ft. lbs.
• Torque master cylinder retaining nuts to 27 ft. lbs.
• Torque power steering hoses to booster n...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, on models with hydraulic assist brakes, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brak...

This system is used on all models except Montana, Silhouette, Tracker, Trans Sport and Venture. On 2000 S & T Series , four door utility vehicles can be equipped with either a 310 or 325 ABS system. Pickups and two-door utility vehicles are equipped with 310 ABS systems. While both systems are functionally the same, the 310 differs in size and appearance from the 325. It is designed to reduce the occurrence of wheel lock-up during severe braking conditions. To accomplish this function, the system regulates hydraulic brake line pressure by using an Electro-Hydraulic Control Unit (EHC...