2002 Cadillac Escalade Brake Service (ONLINE REPAIR MANUALS)

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, on models with hydraulic assist brakes, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brak...

Aztek & Rendezvous

• Remove coolant reservoir, then relieve fuel system pressure as outlined under. "Precautions."
• Remove cruise control cable from module, then disconnect electrical connector from cruise control module.
• Remove cruise control module from bracket, then the front end sheet metal diagonal brace.
• Remove PCM cover from air cleaner housing, then the PCM and set aside.
• Remove air cleaner intake duct, then bolts from air cleaner assembly and housing.
• Remove fuel lines from pipes and vapor line, then disconnect fluid level sensor switch from brake master cylinder.
• Disc...

Height Sensing Proportioning Valve

The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be inspected if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.

• Raise and support vehicle, leave wheels on and allow axle to hang freely.
• Remove lever retaining nut and disconnect lever from valve shaft,. Fig. .
• Rotate valve shaft to permit installation of correct adjustment gauge,. Fig. , ensure D shaped hol...

When wheel slip is detected during a brake application, the ABS enters anti-lock mode. During anti-lock braking, hydraulic pressure in the individual wheel circuits is controlled to prevent any wheel from slipping. A separate hydraulic line and specific solenoid valves are provided for each wheel. The ABS can decrease, hold, or increase hydraulic pressure to each wheel brake. The ABS cannot, however, increase hydraulic pressure above the amount which is transmitted by the master cylinder during braking.

During anti-lock braking, a series of rapid pulsations is felt in the brake pedal...

In order to properly service power brake systems, a thorough understanding of the power assist system is required. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort required to obtain acceptable stopping performance.

Hydraulic assist units incorporate a basic open center spool valve, hydraulic cylinder and an accumulator assembly in a common housing. When the brake pedal is depressed, the hydraulic piston moves forward closing off fluid relief passages, the spool valve applies fluid ...