2002 Chevrolet Suburban 2500 Brake Service (ONLINE REPAIR MANUALS)

C & K Series

Duo-Servo

Removal

• Raise and support vehicle.
• Mark relationship of wheel to hub, then remove tire and wheel assembly.
• On models equipped with full-floating axles, remove hub and drum assembly as outlined in. "Drive Axles."
• On models equipped with semi-floating axles, proceed as follows:
• Install pin into park brake lever.
• Mark relationship of drum to axle.
• Remove rear brake drum retainers, as required.
• Remove rear brake drum.
• On all models, remove return springs and shoe guide,. Fig. .
• Remove brake hold down springs and pins.
• Disconnect actuator lever and pivot.
• Remove lever return sp...

Removal

• Siphon ^2/3 of the brake fluid from master cylinder.
• Raise and support vehicle.
• Remove tire and wheel assembly.
• Compress caliper pistons until they bottom in bores using suitable clamp,. Fig. .
• Disconnect brake hose at caliper by removing inlet fitting bolt.
• Remove mounting bolts and caliper.

Inspection

Should it become required to remove the caliper for installation of new components, clean components in denatured alcohol, wipe dry using lint-free cloths. Blow out drilled passages and holes using compressed air. Inspect dust boots for punctures or tears. If punctures or tears ar...

Aztek & Rendezvous

• Remove coolant reservoir, then relieve fuel system pressure as outlined under. "Precautions."
• Remove cruise control cable from module, then disconnect electrical connector from cruise control module.
• Remove cruise control module from bracket, then the front end sheet metal diagonal brace.
• Remove PCM cover from air cleaner housing, then the PCM and set aside.
• Remove air cleaner intake duct, then bolts from air cleaner assembly and housing.
• Remove fuel lines from pipes and vapor line, then disconnect fluid level sensor switch from brake master cylinder.
• Disc...

In order to properly service power brake systems, a thorough understanding of the various power assist systems is required. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort required to obtain acceptable stopping performance. Two basic types of power assist mechanisms are used: vacuum assist diaphragm assemblies which use engine vacuum and in some cases vacuum from an external vacuum pump, and hydraulic assist assemblies which use hydraulic pressure developed by an external pump (us...

General System

• Inspect components for damage or unusual wear. Replace as required.
• Inspect backing plate mounting bolts and ensure they are tight.
• Inspect wheel cylinders. Excessive fluid indicates cup leakage and need for wheel cylinder replacement. Slight amount of fluid is always present and is considered normal, acting as lubricant for cylinder pistons.
• Inspect adjuster screw operation. If satisfactory, lightly lubricate adjusting screw and washer with suitable brake lube. If operation is unsatisfactory, replace.
• Clean rust and dirt from shoe contact surfaces on backing plate using fi...