Auto Parts Search
We have info for following modifications of 2003 Toyota Tacoma
- 2003 Toyota Tacoma 2.7 L4 GAS, CC:2694, Fuel Injection
- 2003 Toyota Tacoma 3.4 V6 GAS, CC:3378, Fuel Injection
- 2003 Toyota Tacoma 2.4 L4 GAS, CC:2438, Fuel Injection
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Toyota Tacoma AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Toyota Tacoma cars and light trucks sold in the U.S. from 1990+.
Toyota -> Low Coolant Lamp ->
Vehicle: 2003 Toyota Tacoma 2.4 L4 GAS
This lamp will be illuminated when the coolant level in the radiator drops below a pre-determined point. To reset the lamp, bring the c...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota Tacoma MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Toyota Tacoma AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Toyota Tacoma cars and light trucks sold in the U.S. from 1990+.
Toyota -> Air Bag Warning Lamp -> 2003-09 Tacoma
Vehicle: 2003 Toyota Tacoma 3.4 V6 GAS
- Connect two service wires to terminals Tc and CG of data link connector.
- Turn ignition switch to On position and wait for approximately 6 seconds.
- SRS warning lamps will illuminate 2-4 seconds later. Within 1-5 seconds, ground terminal Tc of DLC.
- SRS warning lamp will go off within 2-4 seconds. Within 1-5 seconds, release...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota Tacoma MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Toyota Tacoma AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Toyota Tacoma cars and light trucks sold in the U.S. from 1990+.
Toyota -> Automatic Transmission Overdrive Lamp ->
Vehicle: 2003 Toyota Tacoma 2.7 L4 GAS
The "OD Off" lamp will be illuminated when the ignition switch is in the On position and the Overdrive (OD) switch is in the Off position. When the OD switch is placed in the On position, the "OD Off" lamp should go out. If the lamp flashes when the switch is placed in the On position, a fault has been detected by the electronic control system. After diagnosis and repair are c...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota Tacoma MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Toyota Tacoma AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Toyota Tacoma cars and light trucks sold in the U.S. from 1990+.
Toyota -> Low Oil Level Warning Indicator ->
Vehicle: 2003 Toyota Tacoma 2.7 L4 GAS
This lamp lights to indicate that the engine oil level is below a specified level. The lamp will be illuminated during engine start-up. If...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota Tacoma MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Toyota Tacoma AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Toyota Tacoma cars and light trucks sold in the U.S. from 1990+.
Toyota -> Malfunction Indicator Lamp (MIL) ->
Vehicle: 2003 Toyota Tacoma 2.7 L4 GAS
On some models equipped with OBD II, the MIL will also illuminate if the fuel tank filler cap is not properly tightened. Tighten fuel tank filler cap until it clicks.
The MIL should light when the ignition switch is placed in the On position without starting the engine. When the engine is started, the lamp should go out. If it remains lit, a fault has been detected by the diagnostic system and has logged a diagnostic trouble code. If the fault does not occur again within three trips, the lamp will go out but a diagnostic tro...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota Tacoma MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Toyota Tacoma AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Toyota Tacoma cars and light trucks sold in the U.S. from 1990+.
Toyota -> Low Coolant Lamp ->
Vehicle: 2003 Toyota Tacoma 2.7 L4 GAS
This lamp will be illuminated when the coolant level in the radiator drops below a pre-determined point. To reset the lamp, bring the c...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota Tacoma MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2003 Toyota Tacoma vehicle. |
Access the Complete guide! |