Auto Parts Search

We have info for following modifications of 2004 Chevrolet Colorado
- 2004 Chevrolet Colorado 2.8 L4 GAS, CC:2770, CID:169, Fuel Injection, Aspiration:169, Engine VIN:, Desg:8
- 2004 Chevrolet Colorado 3.5 L5 GAS, CC:3460, CID:211, Fuel Injection, Aspiration:211, Engine VIN:, Desg:6
BRAKE SERVICE PROCEDURES FOR 2004 Chevrolet Colorado AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Chevrolet Colorado cars and light trucks from 1990+.
Power Brake Units -> Delco Brake Booster -> Troubleshooting -> Brakes Grab -> Hard Pedal -> Slow Or No Release
Vehicle: 2004 Chevrolet Colorado 3.5 L5 GAS
Hard Pedal
- Internal vacuum leak.
- Faulty control valve.
- Broken or damaged hydraulic brake lines.
- Collapsed or damaged vacuum hose.
- Plugged or loose vacuum fitting.
- Bad stud welds on front or rear housing on power head.
- Faulty booster diaphragm.
- Restricted air filter element.
- Worn or distorted reaction plate or levers.
- Cracked or broken pow...
CLICK HERE TO GET FULL ACCESS TO 2004 Chevrolet Colorado BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2004 Chevrolet Colorado AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Chevrolet Colorado cars and light trucks from 1990+.
Disc Brakes -> Delco Dual Piston Sliding Caliper -> Brake System Bleed -> Hydraulic System Flush -> Manual Bleed -> Master Cylinder Bleed -> Pressure Bleed
Vehicle: 2004 Chevrolet Colorado 3.5 L5 GAS
Manual Bleed
- If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
- Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
- If master cylinder is suspected to have air in bore, it must be bled first. To bleed master cylinder, proceed as follows:
- Disconnect forward brake pipe connection at master cylinder.
- Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
- Connect and ...
CLICK HERE TO GET FULL ACCESS TO 2004 Chevrolet Colorado BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2004 Chevrolet Colorado AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Chevrolet Colorado cars and light trucks from 1990+.
Hydraulic Brake Systems -> Adjustments -> Height Sensing Proportioning Valve
Vehicle: 2004 Chevrolet Colorado 2.8 L4 GAS
Height Sensing Proportioning Valve
The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be inspected if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.
- Raise and support vehicle, leave wheels on and allow axle to hang freely.
- Remove lever retaining nut and disconnect lever from valve shaft, Fig. .
- Rotate valve shaft to permit installation of correct adjustment gauge, Fig. , ensure D shaped hol...
CLICK HERE TO GET FULL ACCESS TO 2004 Chevrolet Colorado BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2004 Chevrolet Colorado AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Chevrolet Colorado cars and light trucks from 1990+.
Hydraulic Brake Systems -> Adjustments -> Height Sensing Proportioning Valve
Vehicle: 2004 Chevrolet Colorado 3.5 L5 GAS
Height Sensing Proportioning Valve
The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be inspected if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.
- Raise and support vehicle, leave wheels on and allow axle to hang freely.
- Remove lever retaining nut and disconnect lever from valve shaft, Fig. .
- Rotate valve shaft to permit installation of correct adjustment gauge, Fig. , ensure D shaped hol...
CLICK HERE TO GET FULL ACCESS TO 2004 Chevrolet Colorado BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2004 Chevrolet Colorado AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Chevrolet Colorado cars and light trucks from 1990+.
Drum Brakes -> Brake Service -> Aztek, Rendezvous & Vue -> Canyon, Colorado, Sierra & Silverado -> Equinox & Torrent -> Express & Savana -> HHR -> Installation -> Montana, Silhouette, Trans Sport & Venture -> Removal -> Tracker
Vehicle: 2004 Chevrolet Colorado 3.5 L5 GAS
Aztek, Rendezvous & Vue
Removal
- Raise and support vehicle.
- Mark relationship of drum to hub.
- Remove and discard retaining clip.
- Remove brake drum. If brake drum does not come off easily, proceed as follows:
- Loosen parking brake cable.
- Remove backing plate access hole plug.
- Disengage self adjuster by inserting suitable flat-bladed tool through backing plate access hole.
- Loosen adjuster screw by inserting another flat-bladed tool through access hole .
- Install access hole plug.
- Apply small amount of penetrating oil around brake drum center hole.
- Remove brake drum.
- Disengage adjuster spring hook e...
CLICK HERE TO GET FULL ACCESS TO 2004 Chevrolet Colorado BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2004 Chevrolet Colorado AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Chevrolet Colorado cars and light trucks from 1990+.
Disc Brakes -> Delco Dual Piston Sliding Caliper -> Troubleshooting -> Brake Rattle -> Brake Roughness Or Chatter; Pedal Pumping -> Caliper Brake Fluid Leak -> Excessive Pedal Effort -> Excessive Pedal Travel -> Heavy Brake Drag -> No Braking Effect When Brake Pedal Is Depressed -> Pull, Uneven Or Grabbing Brakes -> Rear Brakes Locking On Application
Vehicle: 2004 Chevrolet Colorado 3.5 L5 GAS
Excessive Pedal Travel
- Worn brake linings.
- Disc pads knock back after cornering or rough road travel.
- Piston and linings not properly seated or positioned.
- Insufficient fluid in system.
- Loose wheel bearing adjustment.
- Damaged or worn caliper piston seal.
- Improper booster pushrod adjustment.
- Pads out of flat more than .005 inch.
- Rear brake automatic adjusters inoperative.
- Improperly ground rear brake shoes.
Brake Roughness Or Chatter; Pedal Pumping
- Excessive lateral runout of rotor.
- Rotor excessively out of parallel.
Excessive Pedal Effort
- Frozen or seized pistons.
- Brake fluid, oil or grease on ...
CLICK HERE TO GET FULL ACCESS TO 2004 Chevrolet Colorado BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |