Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2004 Dodge Dakota car and truck
repair procedures including Dodge engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2004 Dodge Dakota automobile. Try the Automotix DIY solution today!
We have info for following modifications of 2004 Dodge Dakota
- 2004 Dodge Dakota 4.7 V8 GAS, CID:285, Fuel Injection, Aspiration:285, Engine VIN:, Desg:N
- 2004 Dodge Dakota 3.7 V6 GAS, CID:226, Fuel Injection, Aspiration:226, Engine VIN:, Desg:K
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Dodge Dakota AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Dodge Dakota cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Emission Maintenance Reminder Indicator -> Chrysler, Dodge & Plymouth
Vehicle: 2004 Dodge Dakota 4.7 V8 GAS
This Emission Maintenance Reminder System (Maintenance Required Lamp) is incorporated into the engine controller. The controller stores vehicle mileage into its memory every eight miles, then at 60,000, 82,500 or 120,000 miles it will light the EMR (Maintenance Required) lamp. When the indicated mileage is reached or the EMR lamp is on at all times, the following components must be replaced and the EMR lamp reset:
- At 60,00 miles, proceed as follows:
- Replace EGR valve.
- Clean EGR passage.
- Replace PCV valve.
- At 82,500 miles, replace oxygen sensor.
- At 120,000 miles, proceed as ...
CLICK HERE TO GET FULL ACCESS TO 2004 Dodge Dakota MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Dodge Dakota AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Dodge Dakota cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Electronic Throttle Control Indicator ->
Vehicle: 2004 Dodge Dakota 4.7 V8 GAS
When the ignition is turned On, the lamp will light for approximately 6-12 seconds as a bulb inspection. If the lamp is illuminated with the engine running, the vehicle is usually drivable but the electronic throttle system must be diagnosed and servic...
CLICK HERE TO GET FULL ACCESS TO 2004 Dodge Dakota MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Dodge Dakota AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Dodge Dakota cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Transmission Temperature Indicator Lamp -> Dodge
Vehicle: 2004 Dodge Dakota 4.7 V8 GAS
If this lamp is lit while operating the vehicle, operate engine at idle speed or fast idle with transmissio...
CLICK HERE TO GET FULL ACCESS TO 2004 Dodge Dakota MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Dodge Dakota AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Dodge Dakota cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Check Engine Lamp -> Chrysler, Dodge, Jeep & Plymouth Except Ram 50
Vehicle: 2004 Dodge Dakota 3.7 V6 GAS
On models less OBD II, the Check Engine lamp should light for approximately 3 seconds after the ignition has been turned On as a bulb inspection. If improper or no signals are received by the Powertrain Control Module (PCM) from various sensors and monitored systems or if the PCM enters its Limp-In mode, the PCM will light the Check Engine lamp. On Chrysler, Dodge and Plymouth models, After diagnosing and servicing the vehicle, the PCM memory will be cleared after approximately 40 to 100 ignition key On-Off cycles or by using a suitable scan tool. ...
CLICK HERE TO GET FULL ACCESS TO 2004 Dodge Dakota MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Dodge Dakota AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Dodge Dakota cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Emission Maintenance Reminder Indicator -> Chrysler, Dodge & Plymouth
Vehicle: 2004 Dodge Dakota 3.7 V6 GAS
This Emission Maintenance Reminder System (Maintenance Required Lamp) is incorporated into the engine controller. The controller stores vehicle mileage into its memory every eight miles, then at 60,000, 82,500 or 120,000 miles it will light the EMR (Maintenance Required) lamp. When the indicated mileage is reached or the EMR lamp is on at all times, the following components must be replaced and the EMR lamp reset:
- At 60,00 miles, proceed as follows:
- Replace EGR valve.
- Clean EGR passage.
- Replace PCV valve.
- At 82,500 miles, replace oxygen sensor.
- At 120,000 miles, proceed as ...
CLICK HERE TO GET FULL ACCESS TO 2004 Dodge Dakota MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Dodge Dakota AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Dodge Dakota cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Traction Control System Warning Lamp ->
Vehicle: 2004 Dodge Dakota 3.7 V6 GAS
This lamp should light for a approximately 6-8 seconds when the ignition is turned On as a bulb check. If the warni...
CLICK HERE TO GET FULL ACCESS TO 2004 Dodge Dakota MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
