Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2004 Infiniti G35 car and truck
repair procedures including Infiniti engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2004 Infiniti G35 automobile. Try the Automotix DIY solution today!
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Infiniti G35 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Infiniti G35 cars and light trucks sold in the U.S. from 1990+.
Infiniti -> Vehicle Dynamic Control (VDC) Warning Lamp ->
Vehicle: 2004 Infiniti G35 3.5 V6 GAS
The VDC lamp should illuminate when the ignition switch is placed in the on position for a few seconds or when the VDC control switch is in the off position. If the VDC lamps illuminates while ope...
CLICK HERE TO GET FULL ACCESS TO 2004 Infiniti G35 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Infiniti G35 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Infiniti G35 cars and light trucks sold in the U.S. from 1990+.
Infiniti -> Tire Pressure Monitoring System (TPMS) Warning Indicator -> 2004-06 G35 -> Activation -> ID Registration -> Less Activation Tool -> Relearn -> Reset -> With Activation Tool
Vehicle: 2004 Infiniti G35 3.5 V6 GAS
Reset
The Low Tire Pressure Warning lamp will illuminate for approximately one second as a bulb check when the ignition switch is placed in the on position. This system uses radio frequency pressure sensors which monitor pressure in all 4 tires. When operating the vehicle at a speed above 20 mph the Low Tire Pressure Warning Lamp will illuminate when low tire pressure has been detected. Adjusting tires to correct pressure will turn lamp off.
Relearn
Activation
The activation procedure must be performed after replacing or rotating tire and wheels, replacing tire pressure sensor or BCM.
- Wi...
CLICK HERE TO GET FULL ACCESS TO 2004 Infiniti G35 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Infiniti G35 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Infiniti G35 cars and light trucks sold in the U.S. from 1990+.
Infiniti -> Malfunction Indicator Lamp (MIL) -> 2001 G20, I30, QX4 & 2002-09 All
Vehicle: 2004 Infiniti G35 3.5 V6 GAS
The MIL will illuminate to indicate that a system fault has been detected. The MIL will blink simultaneously with the red Light Emitting Diode (LED) on the Electronic Control Module (ECM). Following diagnosis and repair of all system faults, reset the MIL lamp. The DTCs can be cleared by placing the ignition switch in the off position. After approximately 10 seconds, place ignition switch in the on position engine not running. Depress the accelerator pedal to change from Mode II to Mode I. Place ignition switch in o...
CLICK HERE TO GET FULL ACCESS TO 2004 Infiniti G35 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Infiniti G35 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Infiniti G35 cars and light trucks sold in the U.S. from 1990+.
Infiniti -> All Wheel Drive (AWD) Warning Lamp ->
Vehicle: 2004 Infiniti G35 3.5 V6 GAS
When the ignition switch is placed in the on position, the AWD warning lamp will light as a bulb check but should go off soon after the engine is started. If a malfunction in the AWD system exist or if fr...
CLICK HERE TO GET FULL ACCESS TO 2004 Infiniti G35 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Infiniti G35 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Infiniti G35 cars and light trucks sold in the U.S. from 1990+.
Infiniti -> Automatic Transmission (AT) Check Engine Lamp ->
Vehicle: 2004 Infiniti G35 3.5 V6 GAS
The Automatic Transmission (AT) Check lamp will be illuminated for approximately 2 seconds when the ignition switch is placed in the on position as a bulb check and then go Off. If it remains lit or comes on at any other time, a malfunction in the a...
CLICK HERE TO GET FULL ACCESS TO 2004 Infiniti G35 MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2004 Infiniti G35 AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2004 Infiniti G35 cars and light trucks sold in the U.S. from 1990+.
Infiniti -> Traction Control/Slip Indicator Lamp ->
Vehicle: 2004 Infiniti G35 3.5 V6 GAS
Drive wheel slippage is detected by the four wheel rotating signal. When wheel slip becomes excessive, the Traction Control System (TCS) operates causing the SLIP indicator lamp to illuminate. When the TCS off switch is used to cancel TCS function, the ...
CLICK HERE TO GET FULL ACCESS TO 2004 Infiniti G35 MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2004 Infiniti G35 vehicle.
|
| Access the Complete guide! |
