Auto Parts Search
We have info for following modifications of 2004 Toyota Celica
- 2004 Toyota Celica GT 1.8 L4 GAS, CC:1794, Fuel Injection, Engine VIN:, Desg:R
- 2004 Toyota Celica GTS 1.8 L4 GAS, CC:1795, Fuel Injection
BRAKE SERVICE PROCEDURES FOR 2004 Toyota Celica AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Toyota Celica cars and light trucks from 1990+.
Toyota -> Rear Disc & Parking Brakes -> Brake Pad Service -> 2003-04 -> 2005 -> Avalon -> Camry, Camry Solara & Sienna -> Celica, Corolla, & MR2 -> Highlander & RAV4 -> Land Cruiser, Sequoia & 4Runner -> Matrix
Vehicle: 2004 Toyota Celica GTS 1.8 L4 GAS
Avalon
2003-04
- Raise and support rear of vehicle, then remove tire and wheel assembly.
- Remove caliper attaching bolts, then the caliper, Fig. . Do not allow caliper to hang unsupported or damage to the brake hose may occur.
- Remove pads and anti-squeal shim(s).
- Remove anti-rattle springs, pad guide plates and support plate.
- Reverse procedure to install.
2005
- Raise and support vehicle, then remove rear wheel.
- Remove union bolt, gasket and flexible hose from brake caliper,
- Remove slide pin and caliper, Fig. .
- Remove brake pads, brake pad support plate and shims.
- Reverse procedure to install...
CLICK HERE TO GET FULL ACCESS TO 2004 Toyota Celica BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2004 Toyota Celica AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Toyota Celica cars and light trucks from 1990+.
Toyota -> Hydraulic Brake Systems -> Component Replacement -> Except Land Cruiser & 4Runner -> Except Sienna -> Land Cruiser & 4Runner -> Master Cylinder -> Models w/Load Sensing Proportioning Valve (LSPV) -> Models w/Proportioning & Bypass Valve (P-BV) -> Proportioning Valve -> Sienna -> Wheel Cylinders
Vehicle: 2004 Toyota Celica GTS 1.8 L4 GAS
Master Cylinder
Except Sienna
- Remove brake fluid with syringe.
- On RAV4 models, remove air cleaner cover with air cleaner hose.
- On all models, label and disconnect brake lines using line wrench 09751-36011, 09023-00100, or equivalent. Cap brake lines from master cylinder.
- Disconnect wire connector from brake pressure switch and then disconnect level warning switch connector, if equipped.
- Remove master cylinder to brake unit attaching nuts, then remove master cylinder, wire clamp, gasket and 3-way union, as needed.
- Reverse procedure to install. Bleed brake system.
Sienna
- Remove air c...
CLICK HERE TO GET FULL ACCESS TO 2004 Toyota Celica BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2004 Toyota Celica AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Toyota Celica cars and light trucks from 1990+.
Toyota -> Power Brake Units -> Troubleshooting
Vehicle: 2004 Toyota Celica GTS 1.8 L4 GAS
Refer to Fig. for gener...
CLICK HERE TO GET FULL ACCESS TO 2004 Toyota Celica BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2004 Toyota Celica AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Toyota Celica cars and light trucks from 1990+.
Toyota -> Front Disc Brakes -> Precautions -> Audio Coded Anti-Theft System
Vehicle: 2004 Toyota Celica GT 1.8 L4 GAS
Audio Coded Anti-Theft System
Some models are equipped with an audio coded anti-theft system that will disable the radio when the battery cable is disconnected. The system can be identified by the "ANTI-THEFT SYSTEM" on the cassette tape lid. Obtain 3 digit customer code for input. Reset system after service as follows:
- Obtain 3 digit audio anti-theft code.
- Depress 1 (PROG) while depressing righthand side of TUNE SEEK button, - - - will appear in tape operation display.
- To enter the first digit, depress 1 (PROG) button repeatedly until the number of times depressed equals the first digit ...
CLICK HERE TO GET FULL ACCESS TO 2004 Toyota Celica BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2004 Toyota Celica AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Toyota Celica cars and light trucks from 1990+.
Toyota -> Rear Disc & Parking Brakes -> Parking Brake Service -> Avalon, Camry, Camry Solara, Celica, Highlander & RAV4 -> Corolla & Matrix -> Land Cruiser, Sequoia, Sienna & 4Runner -> Shoes, Replace
Vehicle: 2004 Toyota Celica GT 1.8 L4 GAS
Avalon, Camry, Camry Solara, Celica, Highlander & RAV4
Shoes, Replace
- Raise and support rear of vehicle, then remove tire and wheel assembly.
- Remove rear caliper.
- Remove rotor disc.
- Remove shoe return springs, Figs. and .
- Remove shoe strut and spring using strut remover 09717-20010, or equivalent.
- Slide front shoe from under shoe hold-down spring, then remove shoe adjusting screw, tension spring and remove shoe.
- Slide rear from shoe hold-down spring, then disconnect parking brake cable from shoe lever.
- Apply non-melting grease on brake backing plate shoe flats, then on shoe slidin...
CLICK HERE TO GET FULL ACCESS TO 2004 Toyota Celica BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2004 Toyota Celica AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2004 Toyota Celica cars and light trucks from 1990+.
Toyota -> Hydraulic Brake Systems -> Component Service -> Assemble -> Disassemble -> Except Sienna -> Inspection -> Master Cylinder -> Overhaul -> Sienna -> Wheel Cylinders
Vehicle: 2004 Toyota Celica GTS 1.8 L4 GAS
Master Cylinder
Except Sienna
Disassemble
For the following procedures, refer to Fig. for assistance.
- Remove master cylinder boot.
- Remove setscrew and reservoir tank, then the cap and strainer from reservoir.
- Remove two grommets and place cylinder in vise.
- Push piston in and remove stopper bolt, Fig. .
- Push pistons in and remove snap ring, then No. 1 piston carefully by hand.
- Place cylinder on edges of two wooden blocks and tap on cylinder until No. 2 piston comes out.
Inspection
Clean components with compressed air. Inspect cylinder bore for rust and scoring. Also, inspect for wear or ...
CLICK HERE TO GET FULL ACCESS TO 2004 Toyota Celica BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2004 Toyota Celica vehicle. |
Access the Complete guide! |