2005 Cadillac SRX Brake Service (ONLINE REPAIR MANUALS)

In order to properly service power brake systems, a thorough understanding of the various power assist systems is required. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort required to obtain acceptable stopping performance. Two basic types of power assist mechanisms are used: vacuum assist diaphragm assemblies which use engine vacuum and in some cases vacuum from an external vacuum pump, and hydraulic assist assemblies which use hydraulic pressure developed by an external pump (us...

When wheel slip is detected during a brake application, the ABS enters anti-lock mode. During anti-lock braking, hydraulic pressure in the individual wheel circuits is controlled to prevent any wheel from slipping. A separate hydraulic line and specific solenoid valves are provided for each wheel. The ABS can decrease, hold, or increase hydraulic pressure to each wheel brake. The ABS cannot, however, increase hydraulic pressure above the amount which is transmitted by the master cylinder during braking.

During anti-lock braking, a series of rapid pulsations is felt in the brake pedal...

Brake Lines & Linings

Remove one of the front wheels and inspect the brake disc, caliper and linings.

Do not allow any oil or grease on the linings. It is recommended that linings be replaced in sets when worn or damaged.

If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.

Brake Roughness

The most common cause of brake chatter on disc brakes is a variation in thickness of the disc. If roughness or vibration is encountered during highway operation or if pedal pumping is experienced at low speeds, the disc may have excessive thickness v...

Manual Bleed

• If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
• Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
• If master cylinder is suspected to have air in bore, it must be bled first. To bleed master cylinder, proceed as follows:
• Disconnect forward brake pipe connection at master cylinder.
• Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
• Connect and ...

The caliper assembly slides on its mounting surfaces, Fig. . Upon brake application, hydraulic pressure against the piston forces the inboard pad against the inboard...

Delco Master Cylinder

When performing the following procedures, refer to Figs. and , noting that the composite reservoir may vary in design.

Disassemble

• Remove master cylinder from vehicle.
• Remove reservoir cover and diaphragm. Discard old brake fluid in reservoir.
• Inspect cover and diaphragm. Replace if cut, cracked or deformed.
• Remove fluid level switch and proportioning valve assembly, if equipped.
• Depress primary piston and remove lock ring.
• Plug primary fluid outlet (outlet nearest to cowl when master cylinder is installed), then apply compressed air into secondary fluid outlet ...