2005 Chevrolet Silverado 3500 Brake Service (ONLINE REPAIR MANUALS)

Brake System Bleed

Gravity and vacuum bleeding procedures are not recommended for use with the anti-lock brake system. The manual bleed procedure is the preferred method, although pressure bleeding is also possible. Do not pump the brake pedal during the bleeding process, as fluid aeration may occur.

Manual Bleed

• Raise and support vehicle, then connect a clear plastic tube to brake bleed screw at righthand rear wheel.
• Place free end of tube in a glass jar partially filled with clean brake fluid. Ensure end of tube remains submerged in fluid and master cylinder reservoir is kept full.
• ...

General System

• Inspect components for damage or unusual wear. Replace as required.
• Inspect backing plate mounting bolts and ensure they are tight.
• Inspect wheel cylinders. Excessive fluid indicates cup leakage and need for wheel cylinder replacement. Slight amount of fluid is always present and is considered normal, acting as lubricant for cylinder pistons.
• Inspect adjuster screw operation. If satisfactory, lightly lubricate adjusting screw and washer with suitable brake lube. If operation is unsatisfactory, replace.
• Clean rust and dirt from shoe contact surfaces on backing plate using fi...

Service Brake

These brakes have self-adjusting shoe mechanisms that ensure correct lining-to-drum clearances at all times. The automatic adjusters operate only when the brakes are applied as the vehicle is moving rearward or when the vehicle comes to an uphill stop.

Although the brakes are self-adjusting, an initial adjustment is required after the brake shoes have been relined or replaced, or when the length of the adjusting screw has been changed during some other service operation.

Frequent usage of an automatic transmission forward range to halt reverse vehicle motion may prevent t...

In order to properly service power brake systems, a thorough understanding of the various power assist systems is required. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort required to obtain acceptable stopping performance. Two basic types of power assist mechanisms are used: vacuum assist diaphragm assemblies which use engine vacuum and in some cases vacuum from an external vacuum pump, and hydraulic assist assemblies which use hydraulic pressure developed by an external pump (us...

Brake Lines & Linings

Remove one of the front wheels and inspect the brake disc, caliper and linings.

Do not allow any oil or grease on the linings. It is recommended that linings be replaced in sets when worn or damaged.

If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.

Brake Roughness

The most common cause of brake chatter on disc brakes is a variation in thickness of the disc. If roughness or vibration is encountered during highway operation or if pedal pumping is experienced at low speeds, the disc may have excessive thickness v...

Master Cylinder

Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.

Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.

The quick take-up uses a spring-loaded ball check val...