Auto Parts Search

We have info for following modifications of 2005 Ford Focus
- 2005 Ford Focus ZX3 2.0 L4 GAS, CID:121, Fuel Injection, Aspiration:121, Engine VIN:, Desg:N
- 2005 Ford Focus ZX5 2.0 L4 GAS, CID:121, Fuel Injection, Aspiration:121, Engine VIN:, Desg:N
- 2005 Ford Focus ZX4 ST 2.3 L4 GAS, CID:140, Fuel Injection, Aspiration:140, Engine VIN:, Desg:Z
- 2005 Ford Focus ZXW 2.0 L4 GAS, CID:121, Fuel Injection, Aspiration:121, Engine VIN:, Desg:N
- 2005 Ford Focus ZX4 2.0 L4 GAS, CID:121, Fuel Injection, Aspiration:121, Engine VIN:, Desg:N
BRAKE SERVICE PROCEDURES FOR 2005 Ford Focus AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Ford Focus cars and light trucks from 1990+.
Drum Brakes -> Focus -> Adjustments -> Parking Brake -> Service Brakes
Vehicle: 2005 Ford Focus ZX5 2.0 L4 GAS
Service Brakes
These models are equipped with self adjusting brake mechanisms and require no adjustment. The brakes are adjusted as required whenever the service brakes are applied.
Parking Brake
- Remove clip and parking brake boot.
- Ensure rear brakes are not hot when adjusting.
- Release parking brake to its lowest position.
- Remove clip and loosen parking brake cable adjustment nut until there is no tension in cable.
- Apply and release brake pedal to ensure brakes are adjusted correctly.
- Raise and support vehicle.
- Ensure parking brake cable is correctly routed in its clips.
- Lower vehicle.
- Raise p...
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Focus BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Ford Focus AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Ford Focus cars and light trucks from 1990+.
Hydraulic Brake Systems -> Hydraulic Brake System Flush
Vehicle: 2005 Ford Focus ZX5 2.0 L4 GAS
Whenever new brake components are installed in the hydraulic system, it is recommended that the entire hydraulic system be thoroughly flushed with clean brake fluid.
It may sometime become required to flush out the system due to the presence of mineral oil, kerosene, gasoline, etc., which will cause swelling of rubber piston cups and valves and render them inoperative.
Flushing is performed at e...
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Focus BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Ford Focus AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Ford Focus cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed -> System Priming -> Wheel Bleeding Sequence
Vehicle: 2005 Ford Focus ZX5 2.0 L4 GAS
Pressure bleeding is recommended for all hydraulic brake systems. Ensure all dirt and contaminants are removed from master cylinder area prior to removing reservoir cap.
To prevent air from the pressure tank getting into the lines, do not shake the tank while air is being added to the tank or after it has been pressurized. Set the tank in the required location, bring the air hose to the tank, and do not move it during the bleeding operation. The tank should be kept at least one-third full.
On vehicles equipped with disc brakes and master cylinders without proportioners or press...
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Focus BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Ford Focus AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Ford Focus cars and light trucks from 1990+.
Power Brake Units -> Clutch System Bleed
Vehicle: 2005 Ford Focus ZXW 2.0 L4 GAS
- Attach a rubber drain hose to bleeder screw of clutch master cylinder, then submerge free end of hose in a container partially filled with clean brake fluid.
- Slowly pump clutch pedal to floor several times and hold it.
- With clutch pedal held to floor...
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Focus BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Ford Focus AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Ford Focus cars and light trucks from 1990+.
Drum Brakes -> Focus -> Tightening Specifications
Vehicle: 2005 Ford Focus ZXW 2.0 L4 GAS
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Focus BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Ford Focus AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Ford Focus cars and light trucks from 1990+.
Drum Brakes -> Focus -> Inspection
Vehicle: 2005 Ford Focus ZX4 2.0 L4 GAS
- Inspect components for damage and unusual wear.
- Inspect wheel cylinders. Boots which are torn, cut, or heat damaged indicate need for wheel cylinder replacement. Fluid spilling from boot center hole or wetness around wheel cylinder ends indicates cup leakage and need for wheel cylinder replacement. A small amount of fluid is always present and is considered normal, acting as lubricant for cylinder pistons.
- Ins...
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Focus BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |