2005 GMC Canyon Brake Service (ONLINE REPAIR MANUALS)

Excessive Pedal Travel

• Worn brake linings.
• Disc pads knock back after cornering or rough road travel.
• Piston and linings not properly seated or positioned.
• Insufficient fluid in system.
• Loose wheel bearing adjustment.
• Damaged or worn caliper piston seal.
• Improper booster pushrod adjustment.
• Pads out of flat more than .005 inch.
• Rear brake automatic adjusters inoperative.
• Improperly ground rear brake shoes.

Brake Roughness Or Chatter; Pedal Pumping

• Excessive lateral runout of rotor.
• Rotor excessively out of parallel.

Excessive Pedal Effort

• Frozen or seized pistons.
• Brake fluid, oil or grease on ...

Aztek, Rendezvous & Vue

Removal

• Raise and support vehicle.
• Mark relationship of drum to hub.
• Remove and discard retaining clip.
• Remove brake drum. If brake drum does not come off easily, proceed as follows:
• Loosen parking brake cable.
• Remove backing plate access hole plug.
• Disengage self adjuster by inserting suitable flat-bladed tool through backing plate access hole.
• Loosen adjuster screw by inserting another flat-bladed tool through access hole .
• Install access hole plug.
• Apply small amount of penetrating oil around brake drum center hole.
• Remove brake drum.
• Disengage adjuster spring hook e...

Manual Bleed

• If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
• Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
• If master cylinder is suspected to have air in bore, it must be bled first. To bleed master cylinder, proceed as follows:
• Disconnect forward brake pipe connection at master cylinder.
• Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
• Connect and ...

Manual Bleed

• If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
• Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
• If master cylinder is suspected to have air in bore, it must be bled first. To bleed master cylinder, proceed as follows:
• Disconnect forward brake pipe connection at master cylinder.
• Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
• Connect and ...

Service Brake

These brakes have self-adjusting shoe mechanisms that ensure correct lining-to-drum clearances at all times. The automatic adjusters operate only when the brakes are applied as the vehicle is moving rearward or when the vehicle comes to an uphill stop.

Although the brakes are self-adjusting, an initial adjustment is required after the brake shoes have been relined or replaced, or when the length of the adjusting screw has been changed during some other service operation.

Frequent usage of an automatic transmission forward range to halt reverse vehicle motion may prevent t...

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level because of a chemical breakdown during use and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent excessiv...