Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2005 Mercury Montego car and truck
repair procedures including Mercury engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2005 Mercury Montego automobile. Try the Automotix DIY solution today!
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Mercury Montego AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Mercury Montego cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Electronic Compass -> 2005-07 Montego -> Calibration Adjustment -> Zone Adjustment
Vehicle: 2005 Mercury Montego 3.0 V6 GAS
Zone Adjustment
- Start the engine.
- Press the INFO button repeatedly until the compass and odometer are displayed. Do not select Trip, DTE, or AFE. The top of the message center must be blank.
- If the compass displays CAL 000000.0 mi instead of heading information, the compass will need to be calibrated.
- Determine compass magnetic zone, Fig. .
- Press and hold the RESET until the message center display changes to show the current zone setting.
- Release the RESET control, then slowly press RESET down again.
- Press the SETUP control repeatedly until the correct zone setting for your geographic ...
CLICK HERE TO GET FULL ACCESS TO 2005 Mercury Montego MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Mercury Montego AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Mercury Montego cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Air Bag Warning Lamp ->
Vehicle: 2005 Mercury Montego 3.0 V6 GAS
This lamp should light for a approximately 6-8 seconds when the ignition is turned On as a bulb check. If the Air B...
CLICK HERE TO GET FULL ACCESS TO 2005 Mercury Montego MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Mercury Montego AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Mercury Montego cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Check Engine Lamp/Malfunction Indicator Lamp (MIL)/Service Engine Soon Lamp -> 1998-2006 Models -> Keep Alive Memory (KAM) Reset & PCM Reset Less Electronic Tester -> PCM Reset Using Generic Scan Tool
Vehicle: 2005 Mercury Montego 3.0 V6 GAS
This lamp should light when the ignition is turned On. After engine starts, the lamp should go off, unless a fault condition is detected by the EEC-V system. If the lamp remains On or starts to blink, a diagnostic trouble code is stored in the PCM. Following diagnosis and repair, the Check Engine/MIL lamp will automatically reset when stored diagnostic trouble codes are cleared from PCM memory. The PCM reset procedure allows the scan tool to command the PCM to clear all diagnostic trouble codes.
A temporary fault such as running out of fuel, poor quality or water in fuel or loos...
CLICK HERE TO GET FULL ACCESS TO 2005 Mercury Montego MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Mercury Montego AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Mercury Montego cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Electronic Throttle Control ->
Vehicle: 2005 Mercury Montego 3.0 V6 GAS
Electronic throttle displays when the system has malfunctioned and the engine has defaulted to a limp-home operation. On vehicles equipped with ...
CLICK HERE TO GET FULL ACCESS TO 2005 Mercury Montego MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Mercury Montego AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Mercury Montego cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Low Oil Level Warning Indicator ->
Vehicle: 2005 Mercury Montego 3.0 V6 GAS
This system is used to indicate when the engine oil level is 11/2 quarts or more below the specified level. The lamp should light during engine starting. If the oil level is sufficient, the lamp will go off when the engine is operating. If the ...
CLICK HERE TO GET FULL ACCESS TO 2005 Mercury Montego MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Mercury Montego AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Mercury Montego cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Low Coolant Lamp ->
Vehicle: 2005 Mercury Montego 3.0 V6 GAS
The low coolant warning lamp should light whenever the coolant level in the coolant recovery bottle is 1/4 to 3/4 inch or more below the cold full mark. Raise coolant level in recovery bottle to the cold full mark to turn lamp off.
On models equipped with GEM module and low coolant level warning system, t...
CLICK HERE TO GET FULL ACCESS TO 2005 Mercury Montego MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2005 Mercury Montego vehicle.
|
| Access the Complete guide! |
