Auto Parts Search
2005 Nissan Quest CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Nissan REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Component Locations
- Wiring Diagrams
- Technical Service Bulletins
- Specifications
- Brake Service
- Fuel Filter Replacement
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
BRAKE SERVICE PROCEDURES FOR 2005 Nissan Quest AUTOMOBILES
Nissan -> Disc Brakes -> Parking Brake Service -> Adjustment -> Frontier & Pathfinder -> Sentra
Vehicle: 2005 Nissan Quest SL 3.5 V6 GAS
Adjustment
Sentra
- Pull parking brake lever with a force of 44 lbs. and ensure lever travels 7-11 notches.
- Rotate adjuster, Fig. , until proper stroke is obtained, then tighten locknut.
Frontier & Pathfinder
- Pull parking brake lever with a force of 44 lb...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest BRAKE SERVICE PROCEDURES
FUEL FILTER REPLACEMENT PROCEDURES FOR 2005 Nissan Quest AUTOMOBILES
Nissan/Datsun -> Fuel Filter Replacement -> Except Armada, Murano, Titan & 350Z, 2006-02 Altima, 2000-06 Maxima & Sentra -> Fuel System Pressure Relief -> Removal & Installation
Vehicle: 2005 Nissan Quest SL 3.5 V6 GAS
Fuel System Pressure Relief
- On all models except 1990-96 300ZX, remove the fuel pump fuse from the fuse panel.
- On 1990-96 300ZX, disconnect the fuel pump relay, located behind the lefthand side kick panel.
- On all models, start and run the engine until it stalls.
- After the engine stalls, crank two or three times to ensure all fuel pressure is relieved.
- On all models except 1990-96 300ZX, turn the ignition Off, then install the fuel pump fuse.
- On 1990-96 300ZX, turn the ignition Off, then connect the fuel pump relay.
Removal &...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest FUEL FILTER REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Nissan Quest AUTOMOBILES
CV AXLE SHAFT, Replace -> Front -> Left Side
Vehicle: 2005 Nissan Quest SE 3.5 V6 GAS
Front
Left Side
- Raise and support vehicle and support it with safety stands in proper locations.
- Remove wheel nuts and front tire.
- Remove ABS wheel sensor from steering knuckle.
- Remove cotter pin and wheel bearing locknut. Discard old cotter pin and install new one upon installation
- Remove brake hose lock plate and remove hose from strut assembly.
- Remove strut assembly and steering knuckle bolt and nut.
- Remove driveshaft from steering knuckle. When removing driveshaft do not apply an excessive angle to driveshaft joint. Be careful not to excessively extend slide joint.
- Remove dri...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2005 Nissan Quest AUTOMOBILES
Relearn Procedures -> Activation -> ID Registration -> Less Activation Tool -> With Activation Tool
Vehicle: 2005 Nissan Quest 3.5 V6 GAS
Activation
The activation procedure must be performed after replacing or rotating tire and wheels, replacing tire pressure sensor or BCM.
- With Nissan sensor activation tool J-45295, or equivalent, pushed against the LF sensor, press and hold the activation tool button 5 seconds, Fig.
- With the ignition switch On, as the low tire pressure warning lamp blinks, Fig. , the respective sensor then must be initialized.
- Register the ID of tire pressure sensor that low tire pressure warning lamp blinks. When Activation of registered wheel has been completed, turn signal lamp blinks two ti...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2005 Nissan Quest AUTOMOBILES
Starter, Replace
Vehicle: 2005 Nissan Quest 3.5 V6 GAS
- Disconnect battery ground cable.
- On models equipped with 4-speed transaxle,remove air cleaner upper case and air cleaner to electric throttle control actuator tube.
- On models equipped with 5-speed transaxle,remove starter motor cover mounting bolts, then the cover.
- On all models, remove starter motor wiring harness protecto...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2005 Nissan Quest AUTOMOBILES
Cabin Air Filter Service -> Nissan -> 2004-09 Quest
Vehicle: 2005 Nissan Quest 3.5 V6 GAS
Under normal operating conditions the cabin air filter should be replaced 15,000 miles. In dusty areas change the cabin air filter more often.
- Open the glove compartment door and remove the damper clip, Fig. .
- Remove glove compartment knob screws, then the knob, Fig. .
- Remove glove compartment hinges.
- Remove glove compartment striker, then the glove compartment screws using suitable screwdriver, Fig. .
- Disconnect the lamp harness and trunk switch.
- Remove the damper from back of instrument passenger lower panel, Fig. .
- Remove the three cabin air filter cover screws, then the cabin a...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Nissan Quest AUTOMOBILES
Nissan -> Check Suspension Warning Lamp ->
Vehicle: 2005 Nissan Quest SE 3.5 V6 GAS
This lamp may indicate a malfunction in the auto-leveling suspension. After diagnosis and rep...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2005 Nissan Quest AUTOMOBILES
Heater Hose, Replace -> Bypass -> Inlet -> Outlet
Vehicle: 2005 Nissan Quest 3.5 V6 GAS
Inlet
- Disconnect battery ground cable.
- Drain cooling system into a suitable container by loosening drain plug of radiator.
- Reposition hose clamp at heater core.
- Remove hose from heater core.
- Reposition hose clamp at water outlet.
- Remove hose from water outlet.
- Remove hose from vehicle.
- Reverse procedure to install.
Outlet
- Disconnect battery ground cable.
- Drain cooling system into a suitable container by loosening drain plug of radiator.
- Reposition hose clamp at heate...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2005 Nissan Quest AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2005 Nissan Quest SE 3.5 V6 GAS
- Rotate or lift the belt tensioner arm, using a suitable tool to relieve tension from dr...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest SERPENTINE BELT SERVICE PROCEDURES
COMPONENT LOCATION DIAGRAMS FOR 2005 Nissan Quest AUTOMOBILES
Component location diagrams for most 2005 Nissan Quest cars and light trucks sold in the U.S. from 1990+.
Auto Light System Diagram for 2005 Nissan Quest 3.5 V6 GAS Components on diagram: |
VDC/TCS/ABS Components Diagram for 2005 Nissan Quest S 3.5 V6 GAS Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest PARTS/COMPONENTS LOCATION DIAGRAMS!
WIRING DIAGRAMS FOR 2005 Nissan Quest AUTOMOBILES
OEM drawn wiring diagrams for most 2005 Nissan Quest cars and light trucks sold in the U.S.
2005 Nissan Quest S 3.5 V6 GAS Wiring Diagram Components on diagram: |
2005 Nissan Quest S 3.5 V6 GAS Wiring Diagram Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest WIRING DIAGRAMS!
TECHNICAL SERVICE BULLETINS FOR 2005 Nissan Quest AUTOMOBILES
OEM TSB listings for most 2005 Nissan Quest cars and light trucks sold in the U.S. from 1985+.
Document: A/C SYSTEM O-RING SEAL LEAKS Vehicle: 2005 Nissan Quest 3.5 V6 GAS Auto Systems: |
Document: SEAT ARMREST LOOSE Vehicle: 2005 Nissan Quest 3.5 V6 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2005 Nissan Quest AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2005 Nissan Quest cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2005 Nissan Quest cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2005 Nissan Quest cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2005 Nissan Quest cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Quest SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2005 Nissan Quest vehicle. |
Access the Complete guide! |