Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2006 Chevrolet Impala car and truck
repair procedures including Chevrolet engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2006 Chevrolet Impala automobile. Try the Automotix DIY solution today!
We have info for following modifications of 2006 Chevrolet Impala
- 2006 Chevrolet Impala LS 3.5 V6 FLEX, CC:3490, CID:213, Fuel Injection, Aspiration:213, Engine VIN:, Desg:K
- 2006 Chevrolet Impala SS 5.3 V8 GAS, CC:5328, CID:325, Fuel Injection, Aspiration:325, Engine VIN:, Desg:C
- 2006 Chevrolet Impala LT 3.9 V6 GAS, CC:3880, CID:237, Fuel Injection, Aspiration:237, Engine VIN:, Desg:1
- 2006 Chevrolet Impala LT 3.5 V6 FLEX, CC:3490, CID:213, Fuel Injection, Aspiration:213, Engine VIN:, Desg:K
- 2006 Chevrolet Impala LTZ 3.9 V6 GAS, CC:3880, CID:237, Fuel Injection, Aspiration:237, Engine VIN:, Desg:1
- 2006 Chevrolet Impala LS 3.9 V6 GAS, CC:3880, CID:237, Fuel Injection, Aspiration:237, Engine VIN:, Desg:1
BRAKE SERVICE PROCEDURES FOR 2006 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Chevrolet Impala cars and light trucks from 1990+.
Hydraulic Brake Systems -> Troubleshooting -> Master Cylinder Internal Fluid Leakage Check -> Road Test
Vehicle: 2006 Chevrolet Impala LTZ 3.9 V6 GAS
When troubleshooting the hydraulic brake system, perform the following inspections.
Master Cylinder Internal Fluid Leakage Check
Start engine and depress the brake pedal. If the pedal gradually falls under constant pressure, the hydraulic system may be leaking. Raise the vehicle on a lift and inspect all tubing lines and backing plates for signs of leakage. It may be required to lift or remove the carpeting or floor mats to inspect for boost...
CLICK HERE TO GET FULL ACCESS TO 2006 Chevrolet Impala BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Chevrolet Impala cars and light trucks from 1990+.
Disc Brakes -> AC-Delco Single Piston Front Disc Brake -> Brake Pad Service
Vehicle: 2006 Chevrolet Impala LS 3.9 V6 GAS
- Remove approximately 2/3 of brake fluid from master cylinder.
- Raise and support front of vehicle, then remove wheel and tire assembly.
- Push piston back into caliper bore using suitable C-clamp, Fig. .
- Do not disconnect brake line fitting from calipe...
CLICK HERE TO GET FULL ACCESS TO 2006 Chevrolet Impala BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Chevrolet Impala cars and light trucks from 1990+.
Disc Brakes -> AC-Delco Single Piston Rear Disc Brake -> Adjustments -> Parking Brake
Vehicle: 2006 Chevrolet Impala LT 3.9 V6 GAS
Parking Brake
- Apply service brake with pedal force of 175 lbs., and release.
- Fully apply parking brake using approximately 125 lbs., of force on final stroke and release.
- Apply and release parking brake two additional times.
- Inspect parking brake pedal assembly for full release by turning ignition On and observing brake warning lamp. Lamp should be off.
- If brake warning lamp is on and parking brake appears to be fully released, operate manual pedal release lever and pull downward on front park brake cable to remove slack from pedal assembly.
- Raise and support vehicle.
- Inspect parking brake...
CLICK HERE TO GET FULL ACCESS TO 2006 Chevrolet Impala BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Chevrolet Impala cars and light trucks from 1990+.
Disc Brakes -> AC-Delco Single Piston Front Disc Brake -> Precautions
Vehicle: 2006 Chevrolet Impala LS 3.5 V6 FLEX
- Keep grease and other foreign material off brake linings, caliper, surfaces of disc and external surfaces of hub.
- Avoid deforming disc, and nicking or scratching brake linings.
- Worn or damaged rubber piston seals should be replaced.
- During removal and installation of a wheel assembly, ensure not to interfere with or damage caliper splash shield, or bleeder screw.
- Front wheel bearing pre...
CLICK HERE TO GET FULL ACCESS TO 2006 Chevrolet Impala BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Chevrolet Impala cars and light trucks from 1990+.
Disc Brakes -> AC-Delco Single Piston Front Disc Brake -> Brake System Bleed -> Bleed Sequence -> Manual -> Pressure
Vehicle: 2006 Chevrolet Impala LT 3.5 V6 FLEX
Manual
Pressure bleeding is recommended for all hydraulic systems. However, if a pressure bleeder is unavailable, use the following procedure. Brake fluid damages painted surfaces. Immediately clean any spilled fluid.
- Remove vacuum reserve by pumping brakes several times with engine off.
- Fill master cylinder reservoir with clean brake fluid. Do not let reservoir fall below half full during bleeding procedure.
- If required, bleed master cylinder as follows:
- Loosen master cylinder forward brake line connection until fluid flows from reservoir, then tighten brake line.
- Have assistant t...
CLICK HERE TO GET FULL ACCESS TO 2006 Chevrolet Impala BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Chevrolet Impala cars and light trucks from 1990+.
Power Brake Units -> Description -> AC-Delco Tandem Diaphragm Type -> Toyota/GM Single Diaphragm Type
Vehicle: 2006 Chevrolet Impala LT 3.5 V6 FLEX
AC-Delco Tandem Diaphragm Type
This unit utilizes a vacuum power chamber, consisting of a front and rear shell, housing divider, front and rear diaphragm, plate assemblies, hydraulic pushrod and a diaphragm return spring, Fig. .
In normal operating mode, with service brakes in released position, the booster operates with vacuum on both sides of its diaphragms. When brakes are applied, air at atmospheric pressure is admitted to one side of each diaphragm to provide power assist. When the service brake is released, atmospheric air is shut off f...
CLICK HERE TO GET FULL ACCESS TO 2006 Chevrolet Impala BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2006 Chevrolet Impala vehicle.
|
| Access the Complete guide! |
