Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2006 Mercury Monterey car and truck
repair procedures including Mercury engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2006 Mercury Monterey automobile. Try the Automotix DIY solution today!
BRAKE SERVICE PROCEDURES FOR 2006 Mercury Monterey AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Mercury Monterey cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed -> Anti-Lock Brake System Hydraulic Control Unit -> Anti-Lock Brakes -> Aviator, Explorer & Mountaineer -> Bench -> Caliper -> E-Series, F-150 & Mark LT -> Escape & Mariner -> Excursion, Explorer Sport/Sport Trac, Freestar, F-Super Duty, Monterey, Motorhome & Ranger -> Expedition & Navigator -> Four Wheel Anti-Lock Brake System -> Gravity Bleed -> In Vehicle -> Manual -> Manual Bleed -> Master Cylinder -> Pressure -> Pressure Bleed
Vehicle: 2006 Mercury Monterey Luxury 4.2 V6 GAS
Aviator, Explorer & Mountaineer
Master Cylinder
- Connect one end of a clear flexible hose to master cylinder bleeder screw. Submerge other end in a container partially filled with suitable brake fluid.
- Have an assistant pump and then hold firm pressure on brake pedal.
- Open master cylinder bleeder screw until brake fluid flows into container.
- When fluid stops flowing, close bleeder screw.
- Repeat procedure until there are no air bubbles in fluid.
- Have an assistant pump and then hold firm pressure on brake pedal.
- Loosen a master cylinder tube fitting at anti-lock brake hydraulic control ...
CLICK HERE TO GET FULL ACCESS TO 2006 Mercury Monterey BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Mercury Monterey AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Mercury Monterey cars and light trucks from 1990+.
Hydraulic Brake Systems -> Adjustments -> E-Series, Expedition, Explorer, Explorer Sport & Sport/Trac, F-150, F-Super Duty, Mark LT, Mountaineer & Navigator -> Master Cylinder Pushrod -> Ranger
Vehicle: 2006 Mercury Monterey Luxury 4.2 V6 GAS
Master Cylinder Pushrod
E-Series, Expedition, Explorer, Explorer Sport & Sport/Trac, F-150, F-Super Duty, Mark LT, Mountaineer & Navigator
- On Expedition, F-150, Mark LT and Navigator models, adjust brake booster to master cylinder pushrod length to .980-.995 inch, Fig. .
- On Explorer, Explorer Sport and Sport/Trac and Mountaineer models, adjus...
CLICK HERE TO GET FULL ACCESS TO 2006 Mercury Monterey BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Mercury Monterey AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Mercury Monterey cars and light trucks from 1990+.
Disc Brakes -> Brake Pad Service
Vehicle: 2006 Mercury Monterey Luxury 4.2 V6 GAS
- Remove and discard a portion of brake fluid from master cylinder.
- Raise and support vehicle, then remove wheel and tire assembly.
- Unclip speed sensor wiring from brake hos...
CLICK HERE TO GET FULL ACCESS TO 2006 Mercury Monterey BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Mercury Monterey AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Mercury Monterey cars and light trucks from 1990+.
Disc Brakes -> Rotor, Replace -> Aviator -> E-Series -> Escape & Mariner -> Excursion, F-Super Duty & Motorhome -> Expedition & Navigator -> Explorer & Mountaineer -> Explorer Sport/Sport Trac -> F-150 & Mark LT -> F-250/350 w/2WD -> F-250/350 w/4WD & F-450/550 -> Freestar & Monterey -> Front -> Installation -> Motorhome -> Ranger -> Rear -> Removal
Vehicle: 2006 Mercury Monterey Luxury 4.2 V6 GAS
Aviator
Front
- Raise and support vehicle.
- Remove front tire and wheel assemblies.
- Remove front brake components in sequence, Fig. .
- Reverse procedure to install.
Rear
Refer to Fig. and remove rear brake components in sequence listed.
Escape & Mariner
- Remove disc brake caliper and anchor plate as outlined in .
- Remove rotor
- Reverse Procedure to install. Tighten all nuts and bolts to specification.
E-Series
Front
Refer to Figs. through and remove components in sequence listed.
Rear
Removal
- Remove disc brake caliper, refer to .
- Remove axle shafts.
- Lift lock washer tab from slot in outer lock nut, Fig...
CLICK HERE TO GET FULL ACCESS TO 2006 Mercury Monterey BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Mercury Monterey AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Mercury Monterey cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> Aviator -> E-Series -> Escape & Mariner -> Excursion & F-Super Duty -> Expedition, Explorer, Explorer Sport & Sport/Trac, F-150, Mark LT, Mountaineer & Navigator -> Freestar & Monterey -> Less Hydro Max -> Master Cylinder -> Ranger -> With Hydro-Max
Vehicle: 2006 Mercury Monterey Luxury 4.2 V6 GAS
Master Cylinder
Aviator
Remove components in sequence illustrated, Fig. .
E-Series
- Drain brake master cylinder with suitable suction device.
- Remove coolant reservoir.
- On models equipped with Hydro Boost, remove three power distribution box bracket bolts and position box aside.
- On all models, remove speed control deactivator switch.
- Disconnect fluid level sensor connector.
- Remove and discard master cylinder mounting nuts.
- Disconnect master cylinder brake tubes.
- Remove master cylinder cylinder.
- Reverse procedure to install, noting the following:
- Torque master cylinder mounting nuts to 18...
CLICK HERE TO GET FULL ACCESS TO 2006 Mercury Monterey BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Mercury Monterey AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Mercury Monterey cars and light trucks from 1990+.
Hydraulic Brake Systems -> Description -> Bendix Hydro-Boost Brake Booster -> Bendix Hydro-Max Brake Booster -> Combination Valve -> Height Sensing Proportioning Valve -> Hydraulic Control Unit (HCU) -> Hydraulic Control Valves -> Integral Bypass Proportioning Valve -> Master Cylinder
Vehicle: 2006 Mercury Monterey Luxury 4.2 V6 GAS
Master Cylinder
The master cylinder consists primarily of a hydraulic cylinder, primary and secondary hydraulic pistons and a single or dual chamber fluid reservoir. The front brakes are connected to the primary outlet port(s) and are actuated by the primary piston assembly. The rear brakes are connected to the secondary outlet port and are actuated by the secondary piston assembly.
Hydraulic Control Valves
Combination Valve
This multi-function hydraulic control unit consists primarily of a pressure differential valve, brake lamp warning switch and a proportioning valve. A pressure diff...
CLICK HERE TO GET FULL ACCESS TO 2006 Mercury Monterey BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2006 Mercury Monterey vehicle.
|
| Access the Complete guide! |
